Manual

Page 6 • JL Audio, Inc., 2016 Continued on Next Page
STEP 40
Reinstall the two T40 Torx screws in the top of
the rear upper panel.
STEP 39
Reinstall the two T40 Torx screws in the center
of the rear upper panel.
STEP 38
Reinstall the T40 Torx screw at each end of the
rear upper panel.
STEP 37
Reinstall the two T40 Torx screws in the center
of the base of the rear upper panel first, as
these secure the Top Bracket to the vehicle.
STEP 36
Be sure the ECU harness is accessible and can
be guided back through the opening in the
rear lower panel.
STEP 35
Reinstall the rear lower panel.
STEP 34
Align the Grille Mesh and Grille Trim over the
rear lower panel. Secure with six 6 - 32 x 3/4”
Stainless Steel Button Head Cap Screws on the
front and six #6 Stainless Steel Flat Washers and
6 - 32 Stainless Steel Nylon Insert Locknuts on
the back.
STEP 33
Remove the Grille Trim. Using a 5/32” drill bit,
enlarge each of the six holes made in the
previous step.
SB-POL-RZG2R/10TW3 INSTR_SKU# 011463