Owner's Manual

Page 11
|
TUNE TAB
“EQUALIZERS” Panel:
Reorder: Re-establishes numerical order (1-10) of parametric EQ band
labels in order of center frequency, from low to high.
(Parametric EQ only)
All Reset: Resets all EQ bands to their default values
All O/On: Temporarily defeats/turns on all EQ bands
EQ Select: Select an EQ to adjust from the pull-down menu (Linked
EQ’s are shown as pairs).
EQ Link: Allows Le and Right EQ Banks to be linked and adjusted
together, with identical settings.
Numerical Entry of EQ values: You can directly enter numerical values
for EQ adjustment into the following entry elds. Use the up/down
arrow icons in each eld for incremental adjustment. Holding the
Shi-Key down while clicking the arrows results in ner resolution. e
following entry elds are available:
FREQ: e center frequency of the EQ band. Default values are in
accordance with ISO full octave EQ band specications: 31, 63, 125,
250, 500, 1000, 2000, 4000, 8000 and 16000 Hz. ese values are
xed in Graphic EQ mode and variable in Parametric EQ mode.
“Q”: e shape of the EQ lter response. Lower “Q” values result
in wider bandwidth EQ lter response. Higher “Q” values result
in narrower bandwidth EQ lter response. is value is xed in
Graphic EQ mode and variable in Parametric EQ mode from 0.26
to 10. Default value is 1.41.
Gain: e amount of amplitude boost or cut applied through the
selected lter, expressed in decibels and adjustable from +6 dB to
–12 dB. Default value is 0 dB. is control is available in Graphic
and Parametric EQ modes.
Manual EQ adjustment on the display graph: e Graphic EQ
uses familiar “slider” control graphics. In Parametric EQ mode, the
numbered, round EQ Band labels on the display graph can be directly
selected and moved using the mouse/touchpad. e graph will display
the resulting eect on frequency response in real time. e resulting
value changes will also be reected in the EQ numerical entry elds.
Manual commands:
Le Click and Hold, then Drag Up/Down for Boost/Cut
Le Click and Hold, then Drag Le/Right to change Center
Frequency (Parametric EQ only)
Right Click and Hold, then Drag Up/Down or Le/Right to change
“Q” (Parametric EQ only)
Control+Le Click to select multiple EQ bands. ese can then be
adjusted together.