Owner's Manual

Page 15
|
Control Linking:
e small selection boxes that correspond to each channel in various
control panels allow you to temporarily link the controls for multiple
channels, for simultaneous adjustment. e selection box at the top of the
panel selects all channels with one click.
Control Linking is incredibly useful, permitting you to execute changes in
multiple channels, while listening to the eect of these changes in real time.
For example, you could select both the le and right tweeter channels and
adjust delay on them, together, while retaining any oset that exists between
them. You can ip the polarity of multiple channels and listen to the result in
real time, or adjust the levels of multiple channels together.
Control Linking is available for the following controls:
Speaker Distance
Polarity
Pre-Crossover Level Trim
High-Pass Filter (Slope changes trigger auto-mute, except in Expert Mode)
Low-Pass Filter (Slope changes trigger auto-mute, except in Expert Mode)
Additional Delay
Output Level Trim
PLEASE NOTE: CONTROL LINKING IS A TEMPORARY ADJUSTMENT STATE
AND IS NOT SAVED IN THE PROJECT FILE.
Appendix A:
Twk™ Input Sensitivity Level Setting
Selecting the appropriate Input Sensitivity setting is critical to achieving
maximum, low distortion output. To properly set the TwK’s Input Sensitivity
settings, perform the steps below prior to making any amplier adjustments.
Necessary Equipment
• CD or le with a pink noise test track.
1. Aer all wiring is complete, connect your TwK™ to a PC and launch the
TüN™ soware. Congure your project, then press the “Master Mute”
button to mute all TwK™ outputs.
2. Turn o all processing (bass/treble, loudness, EQ, etc.) on the source unit
and processors (if used). Set the source unit’s fader and balance controls to
center.
3. Set the source unit volume to ¾ of maximum. is will allow for
reasonable gain overlap with moderate clipping at full volume.
4. Select the Input “Menu” from the SETUP tab and begin playing the
pink noise track (at ¾ source unit volume).
5. Click the dropdown arrow for the rst input channel and, using the
“Signal Level Meter” as a guide, select the setting that does not
exceed the yellow bars. Repeat for the remaining input channels.
Note: When using JL Audio ampliers, set the amplier’s Input Sensitivity
control to twelve o’clock (noon) and Input Voltage switch (if equipped)
to “Low”.