User Guide

INSTALLATION GUIDE

for the

SB-N-FRNTCC/10W1v2

2005 - Up

Nissan Frontier CrewCab Trucks

Thank you for choosing a JL Audio Stealthbox

for your automotive sound system. With proper

installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.

We strongly recommend that you have your new Stealthbox

installed by your authorized JL Audio

dealer. The installation professionals employed by your dealer have the necessary tools and experience

to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage

extends to 1 year if your system is installed or approved by your authorized JL Audio dealer. If you

prefer to perform your own installation, please read this installation guide completely

before beginning the process.

If you choose to perform the installation yourself, it is absolutely vital that

the Stealthbox

be properly mounted to the vehicle according to these

instructions. Failure to mount the enclosure properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the enclosure

caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a collision

or sudden deceleration.

STEP 1

Remove both storage bins from under the rear seat.

If the truck is not equipped with the factory woofer, go to

STEP 4.

Continued on Next Page

STEP 2

Using a 10mm socket, remove the three mounting bolts that

secure the factory woofer enclosure to the truck’s floor.

STEP 3

Using a 10mm socket, remove the two mounting bolts that

secure this mounting bracket to the truck’s floor.

Tuck the factory speaker wire under the carpet and out of

the mounting area of the Stealthbox®.

SB-N-FRNTCC/10W1v2_INSTR_SKU#011229

INSTALLATION

DIFFICULTY:

OUT

ESTIMATED TIME:

1 HOUR

PAGE 1
SB-N-FRNTCC/10W1v2_INSTR_SKU#011229 INSTALLATION D I F F I C U LT Y: I N S TA L L AT I O N G U I D E for the SB-N-FRNTCC/10W1v2 2005 - Up Nissan Frontier CrewCab Trucks If you choose to perform the installation yourself, it is absolutely vital that the Stealthbox® be properly mounted to the vehicle according to these instructions.
PAGE 2
SB-N-FRNTCC/10W1v2_INSTR_SKU#011229 STEP 4 Remove the sill plate. STEP 8 Lower the seat down onto the Stealthbox ®. Line up the top corner of the Stealthbox ® to the bottom corner of the seat. Flip the seat up and push down onto the top of the Stealthbox ®. Unbolt the Z-bracket and remove the Stealthbox ® carefully, leaving the wax square in place. The socket cup set screw will leave an impression in the wax.
PAGE 3
SB-N-FRNTCC/10W1v2_INSTR_SKU#011229 STEP 13 Place a supplied 3/8-inch lock washer and flat washer onto the 3/8-inch bolt. Place the supplied 6mm flat washer onto the 6mm bolt. Using a socket, fully secure the Z-bracket to the truck’s mounting point and on top of the Stealthbox®.