Data Sheet
Table Of Contents
- 1 Description
- 2 RoHS compliance
- 3 Applications
- 4 Software architecture
- 5 Hardware specifications
- 6 Hardware block diagram
- 7 Hardware design
- 8 Regulatory compliance
- 9 Ordering information
- 10 Revision history
Software architecture SPBT2632C2A
8/27 Doc ID 022833 Rev 4
4 Software architecture
4.1 Lower layer stack
● Bluetooth v3.0
● Device power modes: active, sleep and deep sleep
● Wake on Bluetooth feature optimized power consumption of host CPU
● Authentication and encryption
● Encryption key length from 8 bits to 128 bits
● Persistent Flash memory for BD address and user parameter storage
● All ACL (asynchronous connection less) packet types
● Multipoint capability
● Sniff mode: fully supported to maximum allowed intervals
● Master slave switch supported during connection and post connection
● Dedicated inquiry access code for improved inquiry scan performance
● Dynamic packet selection channel quality driven data rate to optimize link performance
● Dynamic power control
● 802.11b co-existence AFH.
4.2 Upper layer stack: Amp'ed UP
● SPP, IAP, SDAP and GAP protocols
● RFComm, SDP, and L2CAP supported
● Multipoint with simultaneous slaves.
4.3 AT command set: abSerial
Please see command list reported in the SPBT2532C2.AT datasheet, Appendix D, for
details.
The complete command list including the iAP commands will be reported in the user
manual UM1547.