Instruction manual

GET TO KNOW THE CRASHER
1. Power On/Off Control
2. Battery Check / Bluetooth Pair Button
3. Pairing/Battery Check LED Indicators
4. Charging Red/Green LED Indicator
5. 3.5mm Audio In Jack to connect non BT devices
6. Micro USB Charge In Jack for charging the speaker
7. Telephone Call Button
8. Volume +
9. Volume –
10. USB Charging Out Jack (to external portable devices)
11. Microphone location
12. Speaker Drivers
13. Back Passive Woofer (located on back panel of unit)
1st Step - CHARGING THE CRASHER
1. Make sure the speaker is fully charged before initial use.
2. Connect the speaker via the Micro USB port (see item 6 above) to your PC or wall outlet using the Micro
USB cable and/or 5V Power Adapter.
3. The Battery LED (see item 4 above) will illuminate in red while charging and should become green once
fully charged.. Another way to check if fully charged, is to click the Battery Check button once (see item 2
above). If all 4 LED indicators light up, your Crasher is almost or fully charged. If only 1 – 3 of the LED
lights light up, please continue charging your device.
4. JLab recommends charging the Crasher overnight with the Micro USB for optimum performance.
5. If you encounter any issues while using your Crasher, please first check to ensure device is fully charged
before troubleshooting the issue and contacting Support.
2nd Step - POWER UP
1. Once the Crasher is fully charged, locate the Power Button toggle switch (see item 1 above).
2. Slide toggle to the right to power on. LED lights and sound should further indicate that the Crasher is on.
3. To power off, slide toggle to the left.
3rd Step - GET CONNECTED VIA BLUETOOTH
1. Make sure the Crasher is turned ON (See 1st and 2nd Step)
2. Press the Pair/Battery Check button and hold for about 5 seconds or until the 4 LEDs flash.
3. Enable the searching mode on your Bluetooth compatible device. (Most commonly found on your
smartphone under Settings, then Bluetooth, then by turning BT On / Searching for Devices.)
4. Select “JLab Crasher” in the list shown on your Bluetooth device / smartphone.
5. Enter “0000” if a password is required.
6. When the Bluetooth connection is made, the first LED will flash slowly. Please allow 10 – 20 seconds for
your device to connect.
7. Once connected, select your music, videos or calls and see your sound instantly amplified with the JLab
Crasher.
8. Please note, only one device may be connected at a time. To connect another Bluetooth device, you must
disconnect with the Crasher from your device / smartphone.
9. To reset the Crasher and void any existing connections, hold down the Pair/Battery Check button (see item