Parts Manual Instruction Manual

3121172 1250AJP 2-113
SECTION 2 TURNTABLE
FIGURE 2-24. 7500W SKYPOWER GENERATOR INSTALLATION - DEUTZ MACHINES
(OPTIONAL)
ITEM # PART NUMBER QTY. DESCRIPTION REV.
Ref. 7500W SKYPOWER GENERATOR INSTALLATION
0273455 Ref. 60Hz Spec (Without UGM) H
1001125427 Ref. 60Hz Spec (With UGM) A
0273456 Ref. 50Hz Spec (Without UGM) F
1001125428 Ref. 50Hz Spec (With UGM) A
Note: SkyPower Generator is Standard On ANSI & CSA
Specs. Optional on All Other Specs.
Note: See Section 7 for Boom Cable Installation.
Ref. Note: For Module Identification, refer to Revision Log page A.
1 0100011 A/R Compound, Locking
2 0100019 A/R Compound, Locking
3 0100048 A/R Grease, Dielectric
4 1 Belt, Generator Options:
0480128 60Hz Spec
0480129 50Hz Spec
5 0641404 5 Bolt 1/4”-20NC x 1/2”
6 0641508 4 Bolt 5/16”-18NC x 1”
7 0641516 3 Bolt, 5/16-18NC x 2”
8 0641810 4 Bolt, 1/2”-13NC x 1 1/4”
9 2 Box, Switch-Weatherhead Options:
0860038 60Hz Spec
Not Available 50Hz Spec (Supply Locally)
10 A/R Box, Generator Control Options:
0861538 1 60Hz Spec
0861572 1 50Hz Spec
7024488 1 Card, Circuit - Generator Power (Not Shown)
Not Available 1 Fuse (Purchase Locally)
7024489 1 Card, Circuit - Control (Not Shown)
Note: Same Circuit Card (P/N 7024489) is used for both
60Hz & 50Hz. When replacing card, rocker switch on
card must be set for required application.
70000619 1 Harness, Circuit Card
11 1 Junction Box Assembly Options (See Items 101-128 for
Breakdown):
0861542 1 60Hz Spec
0861567 1 50Hz Spec
12 0902888 1 Bracket, Generator Junction Box
13 0962520 1 Bushing, Taper
14 2460048 1 Generator, 7500W
70001100 1 Rotor (Includes p/n 70001384 & 70000863) (Not Shown)
70001384 1 Bearing, Shaft (Rear) (Not Shown)
70000863 1 Fan, Generator (Not Shown)
70002088 1 Stator (Not Shown)
70002297 2 Stud 1/4"-20NC x 12 7/8" (Not Shown)
Use 70003631 1 Brushholder Assembly (Not Shown) (was p/n7024484)
14A Use 70004171 1 Key (was p/n 7024561)
14B 70001966 1 Bearing, Ball Radial (Located in Belt Tensioner Endbell)
14C 70001953 1 Endbell, Belt Tensioner