Parts Manual Instruction Manual

2-4 1250AJP 3121172
SECTION 2 TURNTABLE
FIGURE 2-1. VALVE, BATTERY, HORN & AUXILIARY PUMP INSTALLATIONS
ITEM # PART NUMBER QTY. DESCRIPTION REV.
0273377 Ref. VALVES INSTALLATION - TURNTABLE MOUNTED L
1 0100011 A/R Compound, Locking
2 0140001 1 Horn
3 0641406 5 Bolt 1/4”-20NC x 3/4”
4 Not Used
5 0641408 2 Bolt 1/4”-20NC x 1”
6 to 8 Not Used
9 0641608 8 Bolt 3/8"-16NC x 1"
10 Not Used
11 0902800 1 Bracket, Module Mounting
12 1320322 1 Clamp
13 Not Used
14 Use 1001112757 1 Module, B.L.A.M. (Note: Control System must be recalibrated
when Module is replaced) (was p/n 1600332 prior to S/N
0300141570)
2915024 1 Update Kit (Includes Cables, Programming Instructions & CD
Software)
15 3300454 4 Nut, Special
16 to 26 Not Used
27 1 Main Valve Assembly Options (See Figure 2-2 for Breakdown):
Use 1001103793 Prior to S/N 0300119708 (was p/n 4641304)
Use 1001103793 S/N 0300119708 to S/N 0300128768 (was p/n 1001099515)
1001103793 S/N 0300128768 to Present
28 4711400 5 Flatwasher 1/4” Thin
29 Not Used
30 4711600 12 Flatwasher 3/8" Thin
31 Not Used
32 4791400 1 Starwasher 1/4”
33 Not Used
34 0641620 2 Bolt 3/8"-16NC x 2 1/2”
35 0641636 2 Bolt 3/8"-16NC x 4 1/2”
36 3380523 1 Shield, Tube
37 3 Enable Valve Assembly Options:
See Note Prior to S/N 0300131893 (was p/n 4641306, 4641381 &
4641391)
Ref. NOTE: The above listed enable valves & any associated
service parts are no longer available for service. Verify
stamping on valve block. If valve is JLG P/N 4641306
(valve block stamped with P/N CP12673), JLG P/N
4641381 (valve block stamped with P/N HA1022) or JLG
P/N 4641391 (valve block stamped with P/N HA60220) you
must replace all 3 enable valves with JLG P/N
1001106391. If your machine is already equipped with
JLG P/N 1001106391(valve block stamped with P/N
HF46525-08) valves can then be replaced on an as
required basis.
1001112850 S/N 0300131893 to Present (was p/n 1001106391)
7024890 1 Coil