Operator Manual Owner manual
Table Of Contents
- Section 1. SAFETY PRECAUTIONS
- Section 2. USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
- Section 3. MACHINE CONTROLS AND INDICATORS
- Section 4. MACHINE OPERATION
- 4.1 Description
- 4.2 Boom Operating Characteristics and Limitations
- 4.3 CAPACITY SELECT
- 4.4 ENGINE OPERATION
- 4.5 Traveling (Driving)
- 4.6 STEERING
- 4.7 EXTENDING THE AXLES
- 4.8 PLATFORM
- 4.9 Boom
- 4.10 Function Speed control
- 4.11 EMERGENCY TOWING
- 4.12 SHUT DOWN AND PARK
- 4.13 LIFTING AND TIE DOWN
- 4.14 STOWING THE JIB FOR TRANSPORT
- Section 5. LCD DISPLAY PANEL
- 5.1 Description
- 5.2 Boot up Splash Screen
- 5.3 Machine Operating Screen
- 5.4 KeySwitch In Ground Mode:
- 5.5 Function Speed
- 5.6 CAN Bus Lost
- 5.7 Take Foot Out
- 5.8 Put Foot In
- 5.9 BCS Lamp On
- 5.10 Broken Cable
- 5.11 Platform Level
- 5.12 Platform Overload
- 5.13 Capacity Mode Error
- 5.14 Swing DTCs
- 5.15 Jib Unlocked
- 5.16 Jib Locked
- 5.17 Chassis Status
- 5.18 Machine Tilted Mode
- 5.19 Envelope Status
- 5.20 Machine Model Unknown
- Section 6. EMERGENCY PROCEDURES
- Section 7. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
- Section 8. INSPECTION AND REPAIR LOG
SECTION 5 - LCD DISPLAY PANEL
3121618 – JLG Lift – 5-5
Diagnostic Trouble Code (DTC) Tray
This tray shows the total number of DTC’s and the DTC Text. If
there are multiple DTC’s, the operator can scroll through the DTC
List to the end. When the tray is empty, this means there are no
active DTC’s.
Console Tray
This tray represents the platform console information.
When the machine is in operation, and the footswitch is pressed,
the console will show available functions with a green arrow and
unavailable functions with a gray arrow.
NOTE: The green and gray console arrows shown in the examples in this
section may be different depending upon machine setup and
specific operating conditions.
Icons Tray
The Icons Tray shows engine RPM plus Creep and Super Creep
modes.
The RPM level is represented in bars.
Machine Status Tray
The Machine Status Tray is used to display different images based
on the machine status. These include:
• Key Switch Ground Mode
•CAN Bus Lost
•Take Foot Out
• Put Foot In
•BCS Lamp On
• Broken Cable
• System/Basket Level DTCs
•Platform Overload DTCs
•Weight Mode Error
•Swing Left DTC
•Swing Right DTC
•Jib Unlocked
•Jib Locked
•Chassis Status
• In Transport and Out of Transport
• Axles Extended, Retracted, Transient
• Machine Tilted
• Envelope Status
• Unknown Machine Model