Operator Manual Owner manual
Table Of Contents
- Section 1. SAFETY PRECAUTIONS
- Section 2. USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
- Section 3. MACHINE CONTROLS AND INDICATORS
- Section 4. MACHINE OPERATION
- 4.1 Description
- 4.2 Boom Operating Characteristics and Limitations
- 4.3 CAPACITY SELECT
- 4.4 ENGINE OPERATION
- 4.5 Traveling (Driving)
- 4.6 STEERING
- 4.7 EXTENDING THE AXLES
- 4.8 PLATFORM
- 4.9 Boom
- 4.10 Function Speed control
- 4.11 EMERGENCY TOWING
- 4.12 SHUT DOWN AND PARK
- 4.13 LIFTING AND TIE DOWN
- 4.14 STOWING THE JIB FOR TRANSPORT
- Section 5. LCD DISPLAY PANEL
- 5.1 Description
- 5.2 Boot up Splash Screen
- 5.3 Machine Operating Screen
- 5.4 KeySwitch In Ground Mode:
- 5.5 Function Speed
- 5.6 CAN Bus Lost
- 5.7 Take Foot Out
- 5.8 Put Foot In
- 5.9 BCS Lamp On
- 5.10 Broken Cable
- 5.11 Platform Level
- 5.12 Platform Overload
- 5.13 Capacity Mode Error
- 5.14 Swing DTCs
- 5.15 Jib Unlocked
- 5.16 Jib Locked
- 5.17 Chassis Status
- 5.18 Machine Tilted Mode
- 5.19 Envelope Status
- 5.20 Machine Model Unknown
- Section 6. EMERGENCY PROCEDURES
- Section 7. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
- Section 8. INSPECTION AND REPAIR LOG
SECTION 5 - LCD DISPLAY PANEL
5-28 – JLG Lift – 3121618
• When operator switches from Unrestricted to Restricted
mode, the envelope shrinks to indicate reduced operating
envelope.
Example 2: Platform is edge of the envelope
• When Unrestricted or Restricted mode is selected, the dis-
play flashes snail image at a rate of 0.5 seconds in the
machine status tray.
• The envelope color will match the weight mode selected.
Example 3: Unrestricted mode with envelope tilt condition
• When on the Unrestricted envelope screen, if the operator
experiences a tilt condition where tilt is less than what the
machine is configured for, then the envelope will shrink
further to show that the new envelope.
• Display shows animated boom length and boom angle
information along with the new envelope.
• Boom movement is proportional to envelope boundaries.
• Platform location is always at the end of the boom.
Example 4: Restricted mode with envelope tilt condition
• When on the Restricted envelope screen, if the operator
experiences a tilt condition where tilt is less than what the
machine is configured for, then the envelope will shrink
further to show that the new envelope.
• Display shows animated boom length and boom angle
information along with the new envelope.
• Boom movement is proportional to envelope boundaries.
• Platform location is always at the end of the boom.