Operator Manual Owner manual
Table Of Contents
- Section 1. SAFETY PRECAUTIONS
- Section 2. USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
- Section 3. MACHINE CONTROLS AND INDICATORS
- Section 4. MACHINE OPERATION
- 4.1 Description
- 4.2 Boom Operating Characteristics and Limitations
- 4.3 CAPACITY SELECT
- 4.4 ENGINE OPERATION
- 4.5 Traveling (Driving)
- 4.6 STEERING
- 4.7 EXTENDING THE AXLES
- 4.8 PLATFORM
- 4.9 Boom
- 4.10 Function Speed control
- 4.11 EMERGENCY TOWING
- 4.12 SHUT DOWN AND PARK
- 4.13 LIFTING AND TIE DOWN
- 4.14 STOWING THE JIB FOR TRANSPORT
- Section 5. LCD DISPLAY PANEL
- 5.1 Description
- 5.2 Boot up Splash Screen
- 5.3 Machine Operating Screen
- 5.4 KeySwitch In Ground Mode:
- 5.5 Function Speed
- 5.6 CAN Bus Lost
- 5.7 Take Foot Out
- 5.8 Put Foot In
- 5.9 BCS Lamp On
- 5.10 Broken Cable
- 5.11 Platform Level
- 5.12 Platform Overload
- 5.13 Capacity Mode Error
- 5.14 Swing DTCs
- 5.15 Jib Unlocked
- 5.16 Jib Locked
- 5.17 Chassis Status
- 5.18 Machine Tilted Mode
- 5.19 Envelope Status
- 5.20 Machine Model Unknown
- Section 6. EMERGENCY PROCEDURES
- Section 7. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
- Section 8. INSPECTION AND REPAIR LOG
SECTION 1 - SAFETY PRECAUTIONS
1-4 – JLG Lift – 3121618
• Do not carry materials directly on platform railing unless
approved by JLG.
• When two or more persons are in the platform, the operator
shall be responsible for all machine operations.
• Always ensure that power tools are properly stowed and never
left hanging by their cord from the platform work area.
• When driving, always position boom over rear axle in line with
the direction of travel. Remember, if boom is over the front
axle, steer and drive functions will be reversed.
• Do not assist a stuck or disabled machine by pushing or pull-
ing except by pulling at the chassis tie-down lugs.
• Fully lower platform and shut off all power before leaving
machine.
• Remove all rings, watches, and jewelry when operating
machine. Do not wear loose fitting clothing or long hair unre-
strained which may become caught or entangled in equip-
ment.
• Persons under the influence of drugs or alcohol or who are
subject to seizures, dizziness or loss of physical control must
not operate this machine.
Trip and Fall Hazards
• During operation, occupants in the platform must wear a full
body harness with a lanyard attached to an authorized lanyard
anchorage point. Attach only one (1) lanyard per lanyard
anchorage point..
• Enter and exit only through gate area. Use extreme caution
when entering or leaving platform. Ensure that the platform
assembly is fully lowered. Face the machine when entering or
leaving the platform. Always maintain “three point contact”
with the machine, using two hands and one foot or two feet
and one hand at all times during entry and exit.