Operator Manual Owner manual
Table Of Contents
- Section 1. SAFETY PRECAUTIONS
- Section 2. USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
- Section 3. MACHINE CONTROLS AND INDICATORS
- Section 4. MACHINE OPERATION
- 4.1 Description
- 4.2 Boom Operating Characteristics and Limitations
- 4.3 CAPACITY SELECT
- 4.4 ENGINE OPERATION
- 4.5 Traveling (Driving)
- 4.6 STEERING
- 4.7 EXTENDING THE AXLES
- 4.8 PLATFORM
- 4.9 Boom
- 4.10 Function Speed control
- 4.11 EMERGENCY TOWING
- 4.12 SHUT DOWN AND PARK
- 4.13 LIFTING AND TIE DOWN
- 4.14 STOWING THE JIB FOR TRANSPORT
- Section 5. LCD DISPLAY PANEL
- 5.1 Description
- 5.2 Boot up Splash Screen
- 5.3 Machine Operating Screen
- 5.4 KeySwitch In Ground Mode:
- 5.5 Function Speed
- 5.6 CAN Bus Lost
- 5.7 Take Foot Out
- 5.8 Put Foot In
- 5.9 BCS Lamp On
- 5.10 Broken Cable
- 5.11 Platform Level
- 5.12 Platform Overload
- 5.13 Capacity Mode Error
- 5.14 Swing DTCs
- 5.15 Jib Unlocked
- 5.16 Jib Locked
- 5.17 Chassis Status
- 5.18 Machine Tilted Mode
- 5.19 Envelope Status
- 5.20 Machine Model Unknown
- Section 6. EMERGENCY PROCEDURES
- Section 7. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
- Section 8. INSPECTION AND REPAIR LOG
SECTION 1 - SAFETY PRECAUTIONS
3121618 – JLG Lift – 1-11
1.4 TOWING, LIFTING, AND HAULING
• Never allow personnel in platform while towing, lifting, or
hauling.
• This machine should not be towed, except in the event of
emergency, malfunction, power failure, or loading/unloading.
Refer to the Emergency Procedures section of this manual for
emergency towing procedures.
• Ensure boom is in the stowed position and the turntable
locked prior to towing, lifting or hauling. The platform must be
completely empty of tools.
• When lifting machine, lift only at designated areas of the
machine. Lift the unit with equipment of adequate capacity.
• Refer to the Machine Operation section of this manual for lift-
ing information.
1.5 MAINTENANCE
This sub-section contains general safety precautions which must
be observed during maintenance of this machine. Additional pre-
cautions to be observed during machine maintenance are
inserted at the appropriate points in this manual and in the Ser-
vice and Maintenance Manual. It is of utmost importance that
maintenance personnel pay strict attention to these precautions
to avoid possible injury to personnel or damage to the machine
or property. A maintenance program must be established by a
qualified person and must be followed to ensure that the
machine is safe.
Maintenance Hazards
• Shut off power to all controls and ensure that all moving parts
are secured from inadvertent motion prior to performing any
adjustments or repairs.
• Never work under an elevated platform until it has been fully
lowered to the full down position, if possible, or otherwise
supported and restrained from movement with appropriate
safety props, blocking, or overhead supports.
• DO NOT attempt to repair or tighten any hydraulic hoses or fit-
tings while the machine is powered on or when the hydraulic
system is under pressure.
• Always relieve hydraulic pressure from all hydraulic circuits
before loosening or removing hydraulic components.