Operator Manual Owner manual
Table Of Contents
- Section 1. SAFETY PRECAUTIONS
- Section 2. USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
- Section 3. MACHINE CONTROLS AND INDICATORS
- Section 4. MACHINE OPERATION
- 4.1 Description
- 4.2 Boom Operating Characteristics and Limitations
- 4.3 CAPACITY SELECT
- 4.4 ENGINE OPERATION
- 4.5 Traveling (Driving)
- 4.6 STEERING
- 4.7 EXTENDING THE AXLES
- 4.8 PLATFORM
- 4.9 Boom
- 4.10 Function Speed control
- 4.11 EMERGENCY TOWING
- 4.12 SHUT DOWN AND PARK
- 4.13 LIFTING AND TIE DOWN
- 4.14 STOWING THE JIB FOR TRANSPORT
- Section 5. LCD DISPLAY PANEL
- 5.1 Description
- 5.2 Boot up Splash Screen
- 5.3 Machine Operating Screen
- 5.4 KeySwitch In Ground Mode:
- 5.5 Function Speed
- 5.6 CAN Bus Lost
- 5.7 Take Foot Out
- 5.8 Put Foot In
- 5.9 BCS Lamp On
- 5.10 Broken Cable
- 5.11 Platform Level
- 5.12 Platform Overload
- 5.13 Capacity Mode Error
- 5.14 Swing DTCs
- 5.15 Jib Unlocked
- 5.16 Jib Locked
- 5.17 Chassis Status
- 5.18 Machine Tilted Mode
- 5.19 Envelope Status
- 5.20 Machine Model Unknown
- Section 6. EMERGENCY PROCEDURES
- Section 7. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
- Section 8. INSPECTION AND REPAIR LOG
SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-14 – JLG Lift – 3121618
General
Begin the "Walk-Around Inspection" at Item 1, as noted on the
diagram. Continue checking each item in sequence for the con-
ditions listed in the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS OFF.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN CORRECTED.
INSPECTION NOTE: On all components, make sure there are no
loose or missing parts, that they are securely fastened, and no visi-
ble damage, leaks or excessive wear exists in addition to any other
criteria mentioned.
1. Platform Assembly and Gate - Footswitch works prop-
erly, not modified, disabled or blocked. Gate latch and
hinges in working condition.
2. Platform & Ground Control Consoles - Switches and
levers return to neutral, decals/placards secure and legible,
control markings legible.
3. Boom Sections/Turntable - See Inspection Note.
4. Swing Drive - No evidence of damage.
5. Wheel/Tire Assemblies - Properly secured, no missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepan-
cies. Inspect wheels for damage and corrosion.
6. Drive Motor, Brake, and Hub - No evidence of leakage.
7. Hood Assemblies - See Inspection Note.
8. Auxiliary Hydraulic Pump - See Inspection Note.
9. All Hydraulic Cylinders - No visible damage; pivot pins
and hydraulic hoses undamaged, not leaking.
10. Turntable Bearing - Evidence of proper lubrication. No
evidence of loose bolts or looseness between bearing and
machine.
11. Steering Spindles and Sensors - See Inspection Note.
Figure 2-7. Daily Walk-Around Inspection - Sheet 4 of 5