Operator Manual Owner manual
Table Of Contents
- Section 1. SAFETY PRECAUTIONS
- Section 2. USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
- Section 3. MACHINE CONTROLS AND INDICATORS
- Section 4. MACHINE OPERATION
- 4.1 Description
- 4.2 Boom Operating Characteristics and Limitations
- 4.3 CAPACITY SELECT
- 4.4 ENGINE OPERATION
- 4.5 Traveling (Driving)
- 4.6 STEERING
- 4.7 EXTENDING THE AXLES
- 4.8 PLATFORM
- 4.9 Boom
- 4.10 Function Speed control
- 4.11 EMERGENCY TOWING
- 4.12 SHUT DOWN AND PARK
- 4.13 LIFTING AND TIE DOWN
- 4.14 STOWING THE JIB FOR TRANSPORT
- Section 5. LCD DISPLAY PANEL
- 5.1 Description
- 5.2 Boot up Splash Screen
- 5.3 Machine Operating Screen
- 5.4 KeySwitch In Ground Mode:
- 5.5 Function Speed
- 5.6 CAN Bus Lost
- 5.7 Take Foot Out
- 5.8 Put Foot In
- 5.9 BCS Lamp On
- 5.10 Broken Cable
- 5.11 Platform Level
- 5.12 Platform Overload
- 5.13 Capacity Mode Error
- 5.14 Swing DTCs
- 5.15 Jib Unlocked
- 5.16 Jib Locked
- 5.17 Chassis Status
- 5.18 Machine Tilted Mode
- 5.19 Envelope Status
- 5.20 Machine Model Unknown
- Section 6. EMERGENCY PROCEDURES
- Section 7. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
- Section 8. INSPECTION AND REPAIR LOG
SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121618 – JLG Lift – 3-21
12. Drive Orientation Indicator
When the boom is swung beyond the rear
drive tires or further in either direction,
the Drive Orientation indicator will illumi-
nate when the drive function is selected.
This is a signal for the operator to verify
that the drive control is being operated in the proper direc-
tion (i.e. controls reversed situations).
13. Axles Set Indicator
Indicates that the axles are fully extended.
The indicator will flash as the axles are
extending or retracting and be on solid
when fully extended. The light will go out
when the axles are fully retracted.
14. Boom Control System Warning Indicator
Indicates the platform is outside the oper-
ating area and operation of certain boom
functions may be disabled (i.e. lift, tele-
scope). Attempts to use the disabled
functions cause the indicator to flash and
an alarm to sound. Immediately return the platform to the
ground. If the indicator remains lit, a boom control system
fault or failure has been detected. If a failure is discovered,
the system must be repaired by JLG authorized service per-
sonnel before the machine can be used.