Service Manual User Manual

General Information and Specifications
2-12
3614RS, 4017RS
2.3.2 Metric Fastener Torque Chart (Continued)
Values for Magni Coated Fasteners (Ref 4150701)*
CLASS 10.9 METRIC (HEX HEAD) BOLTS CLASS 10 METRIC NUTS,
CLASS 12.9 SOCKET HEAD CAP SCREWS M6 AND ABOVE*
Size Pitch Tensile Stress Area
Clamp Load See
Note 4
Torque
(Dry or Loctite® 263
TM
)
K=0.17
T o r q u e
(Lube or Loctite®
242
TM
or 271
TM
or
Vibra-TITE
TM
111 or 140)
K=0.18
Torque
(Loctite® 262
TM
or
Vibra-TITE
TM
131)
K=0.15
Sq mm KN [N.m] [N.m] [N.m]
3 0.5 5.03 3.13
3.5 0.6 6.78 4.22
4 0.7 8.78 5.47
5 0.8 14.20 8.85
6 1 20.10 12.5 13 12 11
7 1 28.90 18.0 21 20 19
8 1.25 36.60 22.8 31 29 27
10 1.5 58.00 36.1 61 58 55
12 1.75 84.30 52.5 105 100 95
14 2 115 71.6 170 160 150
16 2 157 97.8 265 250 235
18 2.5 192 119.5 365 345 325
20 2.5 245 152.5 520 490 460
22 2.5 303 189.0 705 665 625
24 3 353 222.0 905 850 800
27 3 459 286.0 1315 1235 1160
30 3.5 561 349.5 1780 1680 1575
33 3.5 694 432.5 2425 2285 2140
36 4 817 509.0 3115 2930 2750
42 4.5 1120 698.0 4985 4690 4395
NOTES: 1. THESE TORQUE VALUES DO NOT APPLY TO CADMIUM PLATED FASTENERS 5000059K
2. ALL TORQUE VALUES ARE STATIC TORQUE MEASURED PER STANDARD AUDIT METHODS TOLERANCE = ±10%
3. * ASSEMBLY USES HARDENED WASHER
4. CLAMP LOAD LISTED FOR SHCS IS SAME AS GRADE 8 OR CLASS 10.9 AND DOES NOT REPRESENT FULL STRENGTH CAPABILITY OF SHCS.
IF HIGHER LOAD IS REQUIRED, ADDITIONAL TESTING IS REQUIRED.