Parts Manual User guide

3120827 1-5
S
E
C
T
I
O
N
1
F
R
A
M
E
SECTION 1 FRAME
STEERING INSTALLATION - 4WS REAR
(OPTIONAL)
Ref.
0253059 2WD/4WS Common Machines Built Prior to June
1994
Ref. 7/E
0255006 2WD/4WS Common Mach Built June 1994 to
Present
Ref. 6/D
0252532 4WD/4WS Ref. 7/E
301 4130279 Spindle Weldment (Left Side) 1
302 4130280 Spindle Weldment (Right Side) 2
303 1682967 Steer Cylinder Assy (See Section 5 for Breakdown) 2
304 1660204 Rod-End (Right Hand) 2
305 3322602 Nut, Jam 1"-12NF 2
306 1660205 Rod-End (Left Hand) 2
307 3300228 Nut, Jam 1"-12NF Left Hand Thread 2
308 2160003 Fitting, Grease - 45° 8
309 0642622 Bolt 1"-8NC x 2 3/4" 4
310 4712600 Flatwasher 1" Narrow 4
311 0100019 Loctite (Not Shown) A/R
312 3421190 Kingpin 8
313 0440161 Bearing, Thrust 8
314 to 316 Not Used
317 0641608 Bolt 3/8"-16NC x 1" 16
318 4751600 Flatwasher 3/8" 16
319 1380124 Clip, Retainer (Prior to S/N 69836) 8
320 4920385 Wire, Safety (8 Pieces 1 ft./30cm long) (Prior to
S/N 69836)
8ft/2.4m
321 0100011 Loctite #242 (S/N 69836 to Present) (Not Shown) A/R
FIXED AXLE INSTALLATION (STANDARD PARTS) Ref.
0253171 2WD Ref. 4
0253172 4WD Ref. 3
401 Axle Weldment Options: 1
4844129 2WD (Prior to October 1994)
4844868 2WD (October 1994 to Present)
4844059 4WD (Prior to October 1994)
4844867 4WD (October 1994 to Present)
401A 0961029 Bushing, Bronze (Kingpin Pivot) (4WD Only) 4
402 0560901 Block, Stop 2
403 0641610 Bolt 3/8"-16NC x 1 1/4" 1
404 4740185 Flatwasher 2
405 0100019 Loctite (Not Shown) A/R
406 4842621 Pin Weldment (Prior to October 1994) 1
3422401 Pin Weldment (October 1994 to Present) 1
407 2160002 Fitting, Grease 1
408 3780183 O-Ring (October 1994 to Present) 2
409 4640812 Valve, Relief (October 1994 to Present) 1
410 3820030 Rivet, Pop 3/16" (September 1995 to Present) 6
411 3311605 Nut 3/8"-16NC (September 1995 to Present) 8
FIGURE 1-1. FRAME, STEERING AND AXLE INSTALLATIONS (CONTINUED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.