Parts Manual User guide

3120827 3-3
S
E
C
T
I
O
N
3
S
I
Z
Z
O
R
A
R
M
S
SECTION 3 SIZZOR ARMS
FIGURE 3-1. SIZZOR ARMS INSTALLATION - 40RTS
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.
SIZZOR ARMS INSTALLATIONS - 40RTS Ref.
0252957 Standard Machines Built Prior to May 1993 Ref. A
0254091 Standard Machines Built May 1993 to Present Ref. 8
Note: When using existing pins, Graphokote
Lube (P/N 3020028) is required at installation on
machines built prior to May 1993. When replacing
pivot pins, built prior to May 1993. When replac-
ing pivot pins, at installation.
Ref.
101 Lift Cylinder Assembly (See Section 5 for
Breakdown)
1
Use 1683466 Prior to S/N23500 (was p/n 1682243)
1683466 S/N23500 to Present
102 Pin, Attach (Bottom Lift Cylinder) 1
Use 3422735 Prior to S/N44841 (was p/n 3422073)
3422735 S/N44841 to Present
103 Pin, Attach (Top Lift Cylinder) 1
Use 3422738 Prior to S/N44841 (was p/n 3422074)
3422738 S/N44841 to Present
104 Arm Weldment (2nd Inboard) 1
0200458 Prior to S/N 50201
0200629 S/N 50201 to Present
105 to 106 Not Used
107 Arm Weldment (Bottom Inboard) 1
0200454 Prior to S/N33431
0200556 S/N33431 to Present
108 0200464 Arm Weldment (Bottom Outboard) 1
109 Arm Weldment (4th Outboard) 2
0200452 Prior to S/N 50201
0200628 S/N 50201 to Present
110 0200463 Arm Weldment (4th Inboard) 1
111 0200462 Arm Weldment (3rd Inboard) 1
112 0200461 Arm Weldment (Top Inboard) 1
113 3422271 Pin, Attach 1
114 3422267 Pin, Attach 11
115 3422268 Pin, Attach 1
116 3422272 Pin, Attach 1
117 3422269 Pin, Attach 1
118 3422270 Pin, Attach 4
119 1440227 Collar 30
120 0200403 Arm Weldment (2nd Outboard - Left Side) 1
121 0641528 Bolt 5/16"-18NC x 3 1/2" 30
122 3311505 Locknut 5/16"-18NC 49
123 4843248 Prop, Safety 2
124 Not Used
125 0200402 Arm Weldment (2nd Outboard - Right Side) 1
126 4751700 Flatwasher 7/16" 2
127 3340579 Pad, Sliding 4
128 0681714 Bolt 7/16"-13NC x 1 3/4" (Grade 8) 2
129 3311705 Locknut 7/16"-13NC 2