Parts Manual User guide

3120827 5-13
S
E
C
T
I
O
N
5
C
Y
L
I
N
D
E
R
S
SECTION 5 CYLINDERS
FIGURE 5-5. LIFT CYLINDER ASSEMBLIES
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.
LIFT CYLINDER ASSEMBLIES Ref.
Note: Machines built prior to S/N28190 use cylin-
ders p/n 1682243 or 1682593 which use a T-seal.
When rebuilding these cylinders JLG recommends
using the seal kit listed below per specific model
(40RTS or 33/25RTS) and a p/n 3480214 piston in
place of the original components. The p/n 3480214
piston uses 1 lock ring and 1 seal. If the p/n
3480214 piston has already been installed, the new,
unused piston can be returned to JLG. Machines
built S/N 28190 to present use cylinders p/n
1683465 or 1683466 which already use the p/n
3480214 piston.
Ref.
LIFT CYLINDER ASSEMBLIES Ref.
1683466 40RTS Ref. B
1683465 33RTS and 25RTS Ref. B
1 Barrel Weldment 1
1682080 40RTS
1682594 33RTS and 25RTS
0961379 Bushing, Bronze 2
2 Rod Weldment 1
1682100 40RTS
1682082 33RTS and 25RTS
0961380 Bushing, Bronze 2
3 1120358 Retainer, Head 1
4Head 1
1682076 40RTS
1682098 33RTS and 25RTS
5 Tube, Spacer 1
4564707 40RTS
4565605 33RTS and 25RTS
6 3480214 Piston 1
7 3300286 Nut 1
8 3900170 Setscrew 3/8"-16NC x 3/8" 1
9Not Used
10 Kit Wiper, Rod 1
11 Kit Seal, Rod 1
12 Kit Ring, Wear 1
13 Kit O-Ring 1
14 Kit O-Ring 1
15 Kit Ring, Lock 2
16 Kit Seal, Piston 2
17 2160002 Fitting, Grease 2
18 2180527 Plug, Pipe (Located on Rod End) 1
19 0100011 Loctite #242 A/R
20 0100020 Sealant, Pipe A/R
21 0100035 Loctite #222 A/R
22 0100038 Primer, Locking A/R
— — — — — — — — — —