Service Manual Instruction Manual

SECTION 3 - TROUBLESHOOTING
3120782 – JLG Lift – 3-5
Figure 3-1. Outrigger Socket Contactor Heads and Outrigger Beam - Contactor Plate Mounting Hardware
(ORIGINAL AND 5/2001 - DESIGN).
BRASS COUNTERSUNK
FLAT HEAD SCREW
BRASS LOCKNUT
(USE TO ADJUST PLATE
HEIGHT WHEN TIGHTENING)
NYLON WASHER
NYLON WASHER
STANDARD BRASS NUTS
APPLY LOCTITE #242
TO THREADS
NYLON WASHERS
NYLON WASHERS
INSULATING GROMMET
INSULATING GROMMET
OUTRIGGER BEAM
CONTACTOR PLATE
RELAY WIRE &
ATTACHING EYELET
O/R SOCKET
CONTACTOR SCREW HEAD
FLOOR OF
OUTRIGGER SOCKET
PLATE HEIGHT
ADJUSTMENT
0.175"
0.212"
CONTACTOR SCREW
HEIGHT ADJ.
OUTRIGGER
BEAM ASSEMBLY
TYPICAL
SAFETY DETENT
ARRANGEMENT
ON AM MODELS
(BUTTON HEAD SCREW)
(SEE SUB-SECTION
BELOW - "SAFETY
DETENT SCREWS")
ORIGINAL DE
S
IGN
OUTRIGGER SOCKET
(FLOOR)
OPEN END OF
OUTRIGGER SOCKET
ROUND HEAD SCREW
INSULATOR BUSHING
NYLON WASHERS
NUT
APPLY LOCTITE #242
T
O
THREAD
S
5/2001 - DESIGN
BRASS
FLAT HEAD SCREW
CONTACTOR
PLATE
ACORN NUT
INSULATOR
BUSHING
NYLON
WASHERS
OUTRIGGER BEAM
JACK END OF
OUTRIGGER BEAM
O-RINGS
APPLY LOCTITE #222
TO THREADS