Parts Manual User guide

1-8 3394RT & 4394RT 3121134
SECTION 1 FRAME
103 0641606 AR Bolt 3/8-16NC x 3/4
8 Prior to SN 0200122967
16 SN 0200122967 to SN 0200191606
104 4 Bolt Options:
0681828 1/2-13NC x 3-1/2 (Grade 8) (Prior to SN 0200113943)
0641824 1/2-13NC x 3 (SN 0200113943 to SN 0200191606)
105 Not Used
106 0962140 2 Bearing
107 1 Steer Cylinder Assembly Options (See CYLINDER SECTION for
Breakdown):
Use 1684412 Prior to SN 0200137518 (was p/n 1683614)
1684412 SN 0200137518 to SN 0200191606
108 3312008 4 Nut 5/8-11NC
109 3322201 2 Nut 3/4-16NC
110 4 Kingpin Options:
3422716 Prior to SN 0200122967 (2 Mounting Bolts) (Note: See Kit)
3423081 SN 0200122967 to SN 0200191606 (4 Mounting Bolts)
111 3841367 2 Rod-End with Grease Fitting
112 3900109 4 Screw, Shoulder
113 4061048 1 Shield, Cylinder (Prior to SN 0200113943)
114 1 Spindle (Left Side)
Use 4130403 Prior to SN 0200122967 (Note: See Kit) (was p/n 4130368)
4130403 SN 0200122967 to SN 0200191606
115 1 Spindle (Right Side)
Use 4130404 Prior to SN 0200122967 (Note: See Kit) (was p/n 4130369)
4130404 SN 0200122967 to SN 0200191606
116 4740086 4 Washer, Thrust
117 4891800 4 Flatwasher, Hardened 1/2
118 4846070 2 Rod-End
119 3780182 2 O-Ring (SN 0200122967 to SN 0200191606 Only) (Bottom King-
pin Location Only)
120 to 123 Not Used
124 3020029 AR Grease, Bearing (Not Shown)
— — — — — — — — — —
200 2902400 1 Kingpin and Bushings Update Kit for Machines Built Prior to
SN 0200122967 (Includes Newer “SN 0200122967 to
SN 0200191606 Design Items 18C,18D,102,103,110 & 119).
See Field Service Bulletin AWP-04-11.
Note: Newer bushings will fit in “Prior to SN 0200122967
axles however if kingpin holes measure 1.503 diameter or
larger in any direction, axle weldment must be replaced
before installation of kit.
Note: Spindles require drilling and tapping for 8 additional
kingpin mounting bolts. Newer design kingpins require 4
mounting bolts each.
2360571 Ref FRAME WELDMENT
FIGURE 1-2. AXLE AND STEERING INSTALLATION - 4WD (CONTINUED)
ITEM # PART NUMBER QTY. DESCRIPTION REV.