Operator Manual User guide
Table Of Contents
- FOREWORD
- Section 1. SAFETY PRECAUTIONS
- Section 2. PREPARATION AND INSPECTION
- Section 3. USER RESPONSIBILITIES AND MACHINE CONTROL
- Section 4. MACHINE OPERATION
- Section 5. OPTIONAL EQUIPMENT
- 5.1 Dual Fuel System (Gas Engine Only)
- 5.2 Oscillating Axle
- 5.3 Platform W/soft Touch Proximity System Bumper
- 5.4 Four Wheel Drive
- 5.5 Cold Weather Package
- 5.6 Travel Alarm
- 5.7 Electric Generator
- 5.8 Rotating Beacon
- 5.9 Cylinder Bellows
- 5.10 Boom Wipers
- 5.11 Hostile Environment Package
- 5.12 Motion Alarm
- 5.13 Semi-Track
- Section 6. EMERGENCY PROCEDURES
- Section 7. INSPECTION AND REPAIR LOG
SECTION 4 - MACHINE OPERATION
4-10 – JLG Lift – 3120868
4.13 TOWING
RUNAWAY VEHICLE/MACHINE HAZARD. MACHINE HAS NO TOW-
ING BRAKES. TOWING VEHICLE MUST BE ABLE TO CONTROL
MACHINE AT ALL TIMES. ON-HIGHWAY TOWING NOT PERMIT-
TED. FAILURE TO FOLLOW INSTRUCTIONS COULD CAUSE SERI-
OUS INJURY OR DEATH.
MAXIMUM TOWING SPEED 8 K.M.H. (5 M.P.H.) FOR NO LONGER
THAN 30-45 MINUTES.
MAXIMUM TOWING GRADE 25%.
Prior to towing the machine, complete the
following:
DO NOT TOW MACHINE WITH ENGINE OPERATING OR DRIVE
HUBS ENGAGED.
1. Retract, lower and position boom over rear drive
wheels in line with direction of travel.
2. Disconnect drive hubs by inverting disconnect cap.
(See Figure 4-6.) After towing the machine, com-
plete the following:
3. Reconnect drive hubs by inverting disconnect cap.
(See Figure 4-6.)
Figure 4-6. Drive Disconnect Hub