Parts Manual Owner manual
Table Of Contents
- SECTION 1 FRAME
- FIGURE 1-1. AXLE AND STEERING INSTALLATION - 2WD WITHOUT TOW BAR
- FIGURE 1-2. AXLE AND STEERING INSTALLATION - 2WD WITH TOW BAR (S/N 49971 TO PRESENT)
- FIGURE 1-3. AXLE AND STEERING INSTALLATION - 4WD.
- FIGURE 1-4. TIRE AND WHEEL DRIVE INSTALLATIONS
- FIGURE 1-5. DRIVE BRAKE ASSEMBLY.
- FIGURE 1-6. DRIVE HUB ASSEMBLY (PRIOR TO S/N 39594).
- FIGURE 1-7. DRIVE HUB ASSEMBLY (S/N 39594 TO PRESENT)
- FIGURE 1-8. DRIVE MOTOR ASSEMBLY - REAR
- FIGURE 1-9. DRIVE MOTOR ASSEMBLY - FRONT
- FIGURE 1-10. DRIVE VALVES INSTALLATIONS
- FIGURE 1-11. TOW BAR INSTALLATION - 2WD
- FIGURE 1-12. SEMI-TRACK INSTALLATION
- SECTION 2 TURNTABLE
- FIGURE 2-1. CONTROL VALVES INSTALLATIONS
- FIGURE 2-2. MAIN CONTROL VALVE ASSEMBLY - PROPORTIONAL
- FIGURE 2-3. TURNTABLE AND SWING DRIVE INSTALLATIONS
- FIGURE 2-4. SWING MOTOR ASSEMBLY
- FIGURE 2-5. SWING BEARING ASSEMBLY
- FIGURE 2-6. DEUTZ ENGINE INSTALLATION
- FIGURE 2-7. GENERATOR INSTALLATION - DEUTZ MACHINES (OPTIONAL)
- FIGURE 2-8. PISTON PUMP ASSEMBLY
- FIGURE 2-9. TANK INSTALLATIONS
- FIGURE 2-10. GROUND CONTROL BOX ASSEMBLY
- FIGURE 2-11. ELECTRICAL OPTIONS INSTALLATION (TURNTABLE MOUNTED)
- FIGURE 2-12. HOODS INSTALLATION
- SECTION 3 BOOM
- SECTION 4 PLATFORM
- FIGURE 4-1. PLATFORM INSTALLATION
- FIGURE 4-2. PLATFORM CONSOLE ASSEMBLY
- FIGURE 4-3. CONTROLLER ASSEMBLY (LIFT & SWING) (PRIOR TO S/N39857)
- FIGURE 4-4. CONTROLLER ASSEMBLY (LIFT & SWING) (S/N39857 TO PRESENT)
- FIGURE 4-5. CONTROLLER ASSEMBLY (DRIVE & STEER) (PRIOR TO S/N39857)
- FIGURE 4-6. CONTROLLER ASSEMBLY (DRIVE & STEER) (S/N39857 TO PRESENT)
- FIGURE 4-7. CONTROLLER ASSEMBLY (SPEED)
- FIGURE 4-8. SOFT TOUCH SYSTEM INSTALLATION (S/N 49601 TO PRESENT)
- SECTION 5 CYLINDER
- FIGURE 5-1. AXLE LOCKOUT CYLINDER ASSEMBLY
- FIGURE 5-2. PLATFORM LEVEL CYLINDER ASSEMBLY
- FIGURE 5-3. LIFT CYLINDER ASSEMBLY - JIB (450AJ ONLY)
- FIGURE 5-4. LIFT CYLINDER ASSEMBLY - MAIN
- FIGURE 5-5. LIFT CYLINDER ASSEMBLY - MID
- FIGURE 5-6. LIFT CYLINDER ASSEMBLY - TOWER
- FIGURE 5-7. ROTATOR CYLINDER ASSEMBLY - PLATFORM
- FIGURE 5-8. STEER CYLINDER ASSEMBLY
- FIGURE 5-9. TELESCOPE CYLINDER ASSEMBLY
- SECTION 6 HYDRAULIC
- SECTION 7 ELECTRICAL
- SECTION 8 DECALS
- SECTION 9 RECOMMENDED SERVICE PARTS STOCK
- SECTION 10 SPECIAL OPTIONS
3120870 7-15
SECTION 7 ELECTRICAL
S
E
C
T
I
O
N
7
E
L
E
C
T
R
I
C
A
L
705A Supply Locally Box, Switch 1
Supply Locally Gasket 1
705B Supply Locally Receptacle 1
705C Supply Locally Shield, Cover 1
705D Supply Locally Connector, Strain Relief 1
705E 4460709 Plug, Male 2
705F 4921820 Harness-Receptacle Box to Boom (Prior to S/N
41790 Only)
1
1060461 Cable, Electrical - 12/3
30in/76cm
705G 4460709 Plug, Male 1
705H 4460710 Receptacle, Female 2
706 Generator Electrical Components
4932989 220Volt Prior to S/N 56107 1/B
4933149 220Volt S/N 56107 to Present 2/B
3990010 Diode - 6 Amp (Not Shown) 1
706A 4921938 Harness - On/Off Switch (Powermite Control
Box to Ground Control Box)
1
706B 4460125 Receptacle, Electrical 1
706C 4460125 Receptacle, Electrical 1
707 4922432 Harness - Generator Timer to Relay (S/N 56107
to Present) (Not Shown - Located in Ground
Control Box)
1
708 4921957 Generator to Rear of Boom Harness 1
Note: Harness used to connect AC at platform har-
ness to generator receptacle to power platform
receptacle.
1060461 Cable, Electrical - 12/3
6ft/1.8m
708A Supply Locally Plug, Male (Note: Not Supplied With P/N 4921957) 1
708B 4460710 Receptacle, Female (220V)(Note: Not Supplied With
P/N 4921957)
1
709 2920140 Platform Worklights Harness (Includes Light and
Wire Only)
2
2820035 Loom, Vinyl
9ft/2.8m
709A 4460598 Connector, Strain Relief 1
4460442 Terminal (Not Shown-Located in Platform Con-
sole)
2
710 4922140 2WD/4WD Valve Harness Assembly 1
710A 4460499 Din Connector with Diode 3
711 Not Available Lights Harness 1
1060341 Cable, Electrical - 16/2
37ft/11.3m
712 4922304 Load Sensor Harness (Inside Platform Box) 1
3990010 Diode 6 Amp 1
713 Not Available Load Sensor Harness (Platform Box to Load Control
Box)
1
1060079 Cable, Electrical - 16/4 6ft/1.8m
713A 4460428 Connector, Strain Relief 1
714 Not Available Load Cell Harness (Purchase Load Cell) 1
714A Not Available Connector 1
FIGURE 7-3. HARNESS COMPONENTS INSTALLATION
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.