Parts Manual Owner manual
Table Of Contents
- SECTION 1 FRAME
- FIGURE 1-1. AXLE AND STEERING INSTALLATION - 2WD WITHOUT TOW BAR
- FIGURE 1-2. AXLE AND STEERING INSTALLATION - 2WD WITH TOW BAR (S/N 49971 TO PRESENT)
- FIGURE 1-3. AXLE AND STEERING INSTALLATION - 4WD.
- FIGURE 1-4. TIRE AND WHEEL DRIVE INSTALLATIONS
- FIGURE 1-5. DRIVE BRAKE ASSEMBLY.
- FIGURE 1-6. DRIVE HUB ASSEMBLY (PRIOR TO S/N 39594).
- FIGURE 1-7. DRIVE HUB ASSEMBLY (S/N 39594 TO PRESENT)
- FIGURE 1-8. DRIVE MOTOR ASSEMBLY - REAR
- FIGURE 1-9. DRIVE MOTOR ASSEMBLY - FRONT
- FIGURE 1-10. DRIVE VALVES INSTALLATIONS
- FIGURE 1-11. TOW BAR INSTALLATION - 2WD
- FIGURE 1-12. SEMI-TRACK INSTALLATION
- SECTION 2 TURNTABLE
- FIGURE 2-1. CONTROL VALVES INSTALLATIONS
- FIGURE 2-2. MAIN CONTROL VALVE ASSEMBLY - PROPORTIONAL
- FIGURE 2-3. TURNTABLE AND SWING DRIVE INSTALLATIONS
- FIGURE 2-4. SWING MOTOR ASSEMBLY
- FIGURE 2-5. SWING BEARING ASSEMBLY
- FIGURE 2-6. DEUTZ ENGINE INSTALLATION
- FIGURE 2-7. GENERATOR INSTALLATION - DEUTZ MACHINES (OPTIONAL)
- FIGURE 2-8. PISTON PUMP ASSEMBLY
- FIGURE 2-9. TANK INSTALLATIONS
- FIGURE 2-10. GROUND CONTROL BOX ASSEMBLY
- FIGURE 2-11. ELECTRICAL OPTIONS INSTALLATION (TURNTABLE MOUNTED)
- FIGURE 2-12. HOODS INSTALLATION
- SECTION 3 BOOM
- SECTION 4 PLATFORM
- FIGURE 4-1. PLATFORM INSTALLATION
- FIGURE 4-2. PLATFORM CONSOLE ASSEMBLY
- FIGURE 4-3. CONTROLLER ASSEMBLY (LIFT & SWING) (PRIOR TO S/N39857)
- FIGURE 4-4. CONTROLLER ASSEMBLY (LIFT & SWING) (S/N39857 TO PRESENT)
- FIGURE 4-5. CONTROLLER ASSEMBLY (DRIVE & STEER) (PRIOR TO S/N39857)
- FIGURE 4-6. CONTROLLER ASSEMBLY (DRIVE & STEER) (S/N39857 TO PRESENT)
- FIGURE 4-7. CONTROLLER ASSEMBLY (SPEED)
- FIGURE 4-8. SOFT TOUCH SYSTEM INSTALLATION (S/N 49601 TO PRESENT)
- SECTION 5 CYLINDER
- FIGURE 5-1. AXLE LOCKOUT CYLINDER ASSEMBLY
- FIGURE 5-2. PLATFORM LEVEL CYLINDER ASSEMBLY
- FIGURE 5-3. LIFT CYLINDER ASSEMBLY - JIB (450AJ ONLY)
- FIGURE 5-4. LIFT CYLINDER ASSEMBLY - MAIN
- FIGURE 5-5. LIFT CYLINDER ASSEMBLY - MID
- FIGURE 5-6. LIFT CYLINDER ASSEMBLY - TOWER
- FIGURE 5-7. ROTATOR CYLINDER ASSEMBLY - PLATFORM
- FIGURE 5-8. STEER CYLINDER ASSEMBLY
- FIGURE 5-9. TELESCOPE CYLINDER ASSEMBLY
- SECTION 6 HYDRAULIC
- SECTION 7 ELECTRICAL
- SECTION 8 DECALS
- SECTION 9 RECOMMENDED SERVICE PARTS STOCK
- SECTION 10 SPECIAL OPTIONS
3120870 1-35
S
E
C
T
I
O
N
1
F
R
A
M
E
SECTION 1 FRAME
.
FIGURE 1-10. DRIVE VALVES INSTALLATIONS
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.
DRIVE VALVES INSTALLATION - 2WD Ref.
0258020 Prior to S/N 56958 Ref. E
0270207 S/N 56958 to Present Ref. B
1Not Used
2 0641532 Bolt 5/16”-18NC x 4” 2
3 to 7 Not Used
8 3311505 Locknut 5/16”-18NC 2
9 to 10 Not Used
11 Flow Divider Valve Assembly Options: 1
4640923 Valve (Not Shown - Prior to S/N37577)
7012992 Valve, Cartridge 1
7021625 Seal Kit - 7012992 Cartridge 1
7012993 Orifice 1
4641041 Valve (S/N37577 to Present) C
11A Use 7022396 Valve, Cartridge (Flow Divider) (Was p/n 7017442) 1
7021625 Seal Kit - 7022396 Cartridge 1
11B Use 7022398 Valve, Cartridge (Load Shuttle) (Was p/n 7010542) 1
7023900 Seal Kit - 7022398 Cartridge 1
11C Use 7022397 Valve, Cartridge (Check) (Was p/n 7012930) 2
7022399 Seal Kit - 7022397 Cartridge 2
Not Available Orifice 1
12 4751500 Flatwasher 5/16” 4
DRIVE VALVES INSTALLATION - 4WD Ref.
0258021 Prior to S/N 56958 Ref. F
0270208 S/N 56958 to Present Ref. C
101 0100011 Loctite #242 (Not Shown) A/R
102 0641532 Bolt 5/16”-18NC x 4” 4
103 0641612 Bolt 3/8”-16NC x 1 1/2” 2
104 to 110 Not Used
111 3311505 Locknut 5/16”-18NC
112 to 113 Not Used
114 Flow Divider Valve Assembly Options: 1
4640923 Valve (Not Shown - Prior to S/N37577)
7012992 Valve, Cartridge 1
7021625 Seal Kit - 7012992 Cartridge 1
7012993 Orifice 1
4641041 Valve (S/N37577 to Present) C
114A Use 7022396 Valve, Cartridge (Flow Divider) (Was p/n 7017442) 1
7021625 Seal Kit - 7022396 Cartridge 1
114B Use 7022398 Valve, Cartridge (Load Shuttle) (Was p/n 7010542) 1
7023900 Seal Kit - 7022398 Cartridge 1
114C Use 7022397 Valve, Cartridge (Check) (Was p/n 7012930) 2
7022399 Seal Kit - 7022397 Cartridge 2
Not Available Orifice 1