Parts Manual Owner manual
Table Of Contents
- SECTION 1 FRAME
- FIGURE 1-1. AXLE AND STEERING INSTALLATION - 2WD WITHOUT TOW BAR
- FIGURE 1-2. AXLE AND STEERING INSTALLATION - 2WD WITH TOW BAR (S/N 49971 TO PRESENT)
- FIGURE 1-3. AXLE AND STEERING INSTALLATION - 4WD.
- FIGURE 1-4. TIRE AND WHEEL DRIVE INSTALLATIONS
- FIGURE 1-5. DRIVE BRAKE ASSEMBLY.
- FIGURE 1-6. DRIVE HUB ASSEMBLY (PRIOR TO S/N 39594).
- FIGURE 1-7. DRIVE HUB ASSEMBLY (S/N 39594 TO PRESENT)
- FIGURE 1-8. DRIVE MOTOR ASSEMBLY - REAR
- FIGURE 1-9. DRIVE MOTOR ASSEMBLY - FRONT
- FIGURE 1-10. DRIVE VALVES INSTALLATIONS
- FIGURE 1-11. TOW BAR INSTALLATION - 2WD
- FIGURE 1-12. SEMI-TRACK INSTALLATION
- SECTION 2 TURNTABLE
- FIGURE 2-1. CONTROL VALVES INSTALLATIONS
- FIGURE 2-2. MAIN CONTROL VALVE ASSEMBLY - PROPORTIONAL
- FIGURE 2-3. TURNTABLE AND SWING DRIVE INSTALLATIONS
- FIGURE 2-4. SWING MOTOR ASSEMBLY
- FIGURE 2-5. SWING BEARING ASSEMBLY
- FIGURE 2-6. DEUTZ ENGINE INSTALLATION
- FIGURE 2-7. GENERATOR INSTALLATION - DEUTZ MACHINES (OPTIONAL)
- FIGURE 2-8. PISTON PUMP ASSEMBLY
- FIGURE 2-9. TANK INSTALLATIONS
- FIGURE 2-10. GROUND CONTROL BOX ASSEMBLY
- FIGURE 2-11. ELECTRICAL OPTIONS INSTALLATION (TURNTABLE MOUNTED)
- FIGURE 2-12. HOODS INSTALLATION
- SECTION 3 BOOM
- SECTION 4 PLATFORM
- FIGURE 4-1. PLATFORM INSTALLATION
- FIGURE 4-2. PLATFORM CONSOLE ASSEMBLY
- FIGURE 4-3. CONTROLLER ASSEMBLY (LIFT & SWING) (PRIOR TO S/N39857)
- FIGURE 4-4. CONTROLLER ASSEMBLY (LIFT & SWING) (S/N39857 TO PRESENT)
- FIGURE 4-5. CONTROLLER ASSEMBLY (DRIVE & STEER) (PRIOR TO S/N39857)
- FIGURE 4-6. CONTROLLER ASSEMBLY (DRIVE & STEER) (S/N39857 TO PRESENT)
- FIGURE 4-7. CONTROLLER ASSEMBLY (SPEED)
- FIGURE 4-8. SOFT TOUCH SYSTEM INSTALLATION (S/N 49601 TO PRESENT)
- SECTION 5 CYLINDER
- FIGURE 5-1. AXLE LOCKOUT CYLINDER ASSEMBLY
- FIGURE 5-2. PLATFORM LEVEL CYLINDER ASSEMBLY
- FIGURE 5-3. LIFT CYLINDER ASSEMBLY - JIB (450AJ ONLY)
- FIGURE 5-4. LIFT CYLINDER ASSEMBLY - MAIN
- FIGURE 5-5. LIFT CYLINDER ASSEMBLY - MID
- FIGURE 5-6. LIFT CYLINDER ASSEMBLY - TOWER
- FIGURE 5-7. ROTATOR CYLINDER ASSEMBLY - PLATFORM
- FIGURE 5-8. STEER CYLINDER ASSEMBLY
- FIGURE 5-9. TELESCOPE CYLINDER ASSEMBLY
- SECTION 6 HYDRAULIC
- SECTION 7 ELECTRICAL
- SECTION 8 DECALS
- SECTION 9 RECOMMENDED SERVICE PARTS STOCK
- SECTION 10 SPECIAL OPTIONS
3120870 2-19
SECTION 2 TURNTABLE
S
E
C
T
I
O
N
2
T
U
R
N
T
A
B
L
E
63 3900254 Bolt Shoulder 3/4” x 4” 1
64 4752200 Flatwasher 3/4” 2
65 3312005 Locknut 5/8”-11NC 1
66 0642010 Bolt 5/8”-11NC x 1 1/4” 1
67 4752000 Flatwasher 5/8” 1
68 4845395 Air Intake Adapter Weldment 1
69 0641510 Bolt 5/16”-18NC x 1 1/4” 3
70 3311505 Locknut 5/16”-18NC 3
71 3960407 Gasket 1
72 3790152 O-Ring 1
73 2720351 Coupling, Rubber
4in/10cm
74 2220794 Fitting, Barb 1
75 1320022 Clamp, Hose 6
76 2720058 Hose
12ft/3.7m
77 2220273 Fitting, Reducer 1
78 2750532 Hose
7ft/2.1m
79 2220313 Fitting, 90° 1
80 2220250 Fitting, Reducer 1
81 2220459 Fitting, 90° 1
82 2720271 Hose
12ft/3.7m
83 2180536 Fitting, Straight 1
84 1703162 Decal - Fan 2
85 1701505 Decal - Diesel Fuel (Not Shown) 1
86 4640751 Valve, Oil Drain 1
87 0902444 Bracket, Hood Support 1
88 0902443 Bracket, Latch Mount 1
89 4240099 Tie-Strap 1
90 2200222 Plug, Pipe (Not Shown - Located at Bottom of Fuel Tank) 1
91 4751800 Flatwasher 1/2” 4
92 1703876 Decal - Engine Tray Swing 1
93 4791400 Starwasher 1/4” 4
94 4791600 Starwasher 3/8” 2
95 1320222 J-Clamp (S/N 45905 to Present) 4
MUFFLER INSTALLATION OPTIONS Ref.
101 Muffler Options: 1
3220110 Standard
3220112 Catalytic
ENGINE COMPONENTS Ref.
2000154 Prior to S/N 41036 B
2000162 S/N 41036 to Present B
201 Use 7020410 Alternator (was p/n 7016329) 1
70000851 Bracket, Alternator Mounting 1
202 7016330 Switch, Oil Pressure 1
203 7016332 Starter 1
FIGURE 2-6. DEUTZ ENGINE INSTALLATION (CONTINUED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.