Service Manual Manual

SECTION 3 - CHASSIS & TURNTABLE
3-210 – JLG Lift – 3120788
DTC to SPN/FMI Table
FAULT
INDEX
DESCRIPTION
DTC SET
SPN FMI
2 DTC 118: ECT voltage high 110 3
3 DTC 117: ECT voltage low 110 4
4 DTC 116: ECT higher than expected stage 1 110 15
9 DTC 563: Vbat voltage high 168 15
10 DTC 562: Vbat voltage low 168 17
11 DTC 643: Sensor supply voltage 1 high 1079 3
12 DTC 642: Sensor supply voltage 1 low 1079 4
13 DTC 123: TPS1 voltage high 51 3
14 DTC 122: TPS1 voltage low 51 4
29 DTC 524: Oil pressure low 100 1
86 DTC 217: ECT higher than expected stage 2 110 0
89 DTC 2112: Unable to reach higher TPS 51 7
90 DTC 2111: Unable to reach lower TPS 51 7
96 DTC 336: CRANK input signal noise 636 2
98 DTC 606: Microprocessor failure - COP 629 31
99 DTC 1612: Microprocessor failure - RTI 1 629 31
100 DTC 1613: Microprocessor failure - RTI 2 629 31
101 DTC 1614: Microprocessor failure - RTI 3 629 31
102 DTC 1615: Microprocessor failure - A/D 629 31
103 DTC 1616: Microprocessor failure - Interrupt 629 31
104 DTC 601: Microprocessor failure - FLASH 628 13
105 DTC 604: Microprocessor failure - RAM 630 12
106 DTC 219: RPM higher than max allowed govern speed 515 15
144 DTC 337: Crank signal loss 636 4
145 DTC 1625: J1939 shutdown request 1384 31
146 DTC 1626: CAN-J1939 Tx fault 639 12
147 DTC 1627: CAN-J1939 Rx fault 639 12
175 DTC 1628: J1939 CAN address / engine-number conflict 639 13
188 DTC 521: Oil pressure high 100 0
189 DTC 1652: TPS1 loss of communications 51 9
190 DTC 1629: CAN-J1939 TSC1 Parameter Rx Fault 695 9
191 DTC 1113: Unable to achieve lower RPM 515 31
192 DTC 9999: TPS1 failsafe spring failure 51 7