Service Manual Instruction Manual
Table Of Contents
- Section A. Introduction - Maintenance Safety Precautions
- Section 1. Specifications
- Section 2. General
- Section 3. Chassis & Turntable
- 3.1 Tires And Wheels
- 3.2 Torque Hub
- Oil Information
- Roll and Leak Testing
- Tightening and Torquing Bolts
- Main Disassembly
- Output Carrier Disassembly
- Input Carrier Disassembly
- Hub-Spindle Disassembly
- Spindle-Brake Disassembly
- Cover Disassembly
- Cover Assembly
- Input Carrier Sub-Assembly
- Output Planet Gear Sub-Assembly
- Spindle - Brake Sub-Assembly
- Hub-Spindle Sub-Assembly
- Cover Sub-Assembly
- Main Assembly
- Integral Brake Check
- 3.3 Free Wheeling Option
- 3.4 Drive Motor
- 3.5 Oscillating Axle Bleeding Procedure and Lockout Test
- 3.6 Steer Adjustments
- 3.7 Swing Drive
- 3.8 Swing Bearing
- 3.9 Swing Brake - Mico
- 3.10 Rotary Coupling
- 3.11 Generator
- 3.12 Deutz D2.9 L4 Engine
- 3.13 Deutz D2011 Engine
- 3.14 Spark Arrester Cleaning Instructions
- 3.15 Glow Plugs
- 3.16 Deutz EMR 2
- 3.17 Bio Fuel in Deutz Engines
- 3.18 GM Engine General Maintenance
- 3.19 GM Engine Dual Fuel System
- Fuel Filter
- Direct Electronic Pressure Regulator (DEPR)
- Air Fuel Mixer
- Electronic Throttle Control (ETC)
- Electric Lock Off
- Engine Control Module (ECM)
- Heated Exhaust Gas Oxygen Sensor
- Gasoline Multi Point Fuel Injection System (MPFI)
- Gasoline Fuel Pump
- Gasoline Pressure And Temperature Sensor Manifold
- Fuel Filter
- Fuel Injector Rail
- Fuel Injector
- 3.20 GM Engine Fuel System Repair
- Propane Fuel System Pressure Relief
- Propane Fuel System Leak Test
- Propane Fuel Filter Replacement
- Direct Electronic Pressure Regulator (DEPR) Maintenance And Inspection
- Check/Drain Oil Build-Up In 2-Stage Vaporizer
- Air Fuel Mixer/Throttle Control Device Maintenance And Inspection
- Exhaust System And Catalytic Converter Inspection And Maintenance
- Temperature Manifold Absolute Pressure (TMAP) Sensor
- Throttle Body (ETC) Replacement
- Mixer Replacement
- Electronic Pressure Regulator (EPR) Replacement
- Regulator Replacement
- Coolant Hose Replacement
- Vapor Hose Replacement
- Engine Control Module Replacement
- Heated Exhaust Gas Oxygen Sensor Replacement
- 3.21 GM Engine LPG Fuel System Diagnosis
- Section 4. Boom & Platform
- Section 5. Hydraulics
- 5.1 O-Ring Lubrication
- 5.2 Cylinders - Theory of Operation
- 5.3 Cylinder Checking Procedure
- 5.4 Cylinder Removal and Installation
- Cylinder Locations
- Main Boom Telescope Cylinder Removal
- Main Boom Telescope Cylinder Installation
- Main Boom Lift Cylinder Removal
- Main Boom Lift Cylinder Installation
- Upright Level Cylinder Removal
- Upright Level Cylinder Installation
- Tower Boom Lift Cylinder Removal
- Tower Lift Cylinder Installation
- Tower Telescope Cylinder Removal
- Tower Telescope Cylinder Installation
- 5.5 Hydraulic Cylinder repair
- Tower Boom Lift Cylinder
- Cleaning and Inspection
- Assembly
- Upright Level Cylinder
- Cleaning and Inspection
- Assembly
- Master Cylinder
- Cleaning and Inspection
- Assembly
- Main Boom Lift Cylinder
- Cleaning and Inspection
- Assembly
- Main Boom Telescope Cylinder
- Cleaning and Inspection
- Assembly
- Tower Boom Telescope Cylinder
- Cleaning and Inspection
- Assembly
- Platform Level (Slave) Cylinder
- Cleaning and Inspection
- Assembly
- Jib Lift Cylinder (AJ Only)
- Cleaning and Inspection
- Assembly
- Steer Cylinder
- Cleaning and Inspection
- Assembly
- Axle Lockout Cylinder
- 5.6 Hydraulic Pump (Gear)
- 5.7 Variable Pump
- 5.8 Hydraulic Component Start-Up
- 5.9 Pressure Setting Procedures
- Section 6. JLG Control System
- Section 7. Basic Electrical Information & Schematics
SECTION 6 - JLG CONTROL SYSTEM
6-44 – JLG Lift – 3121616
8211 LSS READING UNDER WEIGHT
8639 FRONT LEFT STEER VALVE - OPEN CIRCUIT
8640 FRONT LEFT STEER VALVE - SHORT TO BATTERY
8641 FRONT LEFT STEER VALVE - SHORT TO GROUND
8642 FRONT RIGHT STEER VALVE - OPEN CIRCUIT
8643 FRONT RIGHT STEER VALVE - SHORT TO BATTERY
8644 FRONT RIGHT STEER VALVE - SHORT TO GROUND
8669 OSCILLATING AXLE SWITCH DISAGREEMENT
991 LSS WATCHDOG RESET
992 LSS EEPROM ERROR
993 LSS INTERNAL ERROR - PIN EXCITATION
994 LSS INTERNAL ERROR - DRDY MISSING FROM A/D
998 EEPROM FAILURE - CHECK ALL SETTINGS
9910 FUNCTIONS LOCKED OUT - PLATFORM MODULE SOFTWARE VERSION
IMPROPER
9911 FUNCTIONS LOCKED OUT - LSS MODULE SOFTWARE VERSION IMPROPER
9915 CHASSIS TILT SENSOR NOT GAIN CALIBRATED
9919 GROUND SENSOR REF VOLTAGE OUT OF RANGE
9920 PLATFORM SENSOR REF VOLTAGE OUT OF RANGE
9921 GROUND MODULE FAILURE - HIGH SIDE DRIVER CUTOUT FAULTY
9922 PLATFORM MODULE FAILURE - HWFS CODE 1
9924 FUNCTIONS LOCKED OUT - MACHINE NOT CONFIGURED
9927 GROUND MODULE CONSTANT DATA UPDATE REQUIRED
9944 CURRENT FEEDBACK GAINS OUT OF RANGE
9945 CURRENT FEEDBACK CALIBRATION CHECKSUM INCORRECT
9949 MACHINE CONFIGURATION OUT OF RANGE - CHECK ALL SETTINGS
9977 LSS CORRUPT EEPROM
9979 FUNCTIONS LOCKED OUT - GROUND MODULE SOFTWARE VERSION IMPROPER
9986 GROUND MODULE VLOW FET FAILURE
Table 6-6. Fault Code List
DTC Text