Service Manual

SECTION 3 - CHASSIS & TURNTABLE
3121202 – JLG Lift – 3-115
Exhaust System Checks
² Ch eck the exh aus t system f or a possib le r estricti on:
- Inspect the exhaust system for damaged or collapsed pipes
- Inspect the muffler for signs of heat distress or for possible internal failure.
² Check for possible plugged catalytic converter. Refer to Restricted Exhaust System Diagnosis
Hard Start
DEFINITION: The engine cranks OK, but does not start for a long time. The engine does eventually run, or may start but immediately dies.
Preliminary Checks
² Refer to Important Preliminary Checks.
² Make sure the vehicle's operator is using the correct starting procedure.
Sensor Checks
²Check the Engine Coolant Temperature sensor with the scan tool. Compare the engine coolant temperature with the
ambient air temperature on a cold engine. IF the coolant temperature reading is more than 5 degrees greater or less
than the ambient air temperature on a cold engine, check for high resistance in the coolant sensor circuit. Refer to
DTC 111
² Check the Crankshaft Position (CKP) sensor.
²Check the Throttle position (TPS) sensor.
Fuel System Checks
Important: A closed LPG manual fuel shut off valve will create an extended crank OR no start condition.
² Verify the excess flow valve in the LPG manual shut-off valve is not tripped.
² Check mixer module assembly for proper installation and leakage.
² Verify proper operation of the low pressure lock-off solenoids.
² Verify proper operation of the EPR
² Check for air intake system leakage between the mixer and the throttle body.
² Check the fuel system pressures. Refer to the Fuel System Diagnosis.
Ignition System Checks
Note: LPG being a gaseous fuel requires higher secondary ignition system voltages for the equivalent gasoline oper-
ating conditions.
² Check for the proper ignition voltage output with J 26792 or the equivalent.
² Verify that the spark plugs are correct for use with LPG (R42LTS)
² Check the spark plugs for the following conditions:
- Wet plugs
- Cr ack s
- Wea r
- Improper gap
- Burned electrodes
- Heav y deposits
² Check for bare or shorted ignition wires.
² Check for moisture in the distributor cap if applicable.
² Check for loose ignition coil connections.
Important:
1. If the engine starts but then immediately stalls, Check the Crankshaft Position (CKP).
2. Check for improper gap, debris or faulty connections.
Engine Mechanical Checks
Important: The LPG Fuel system works on a fumigation principle of fuel introduction and is more sensitive to intake
manifold leakage than the gasoline fuel supply system.
² Check for the following:
- Vac uum leaks
- Im pro per valve t iming
- Lo w co mpression
- Be nt p ushrods
- Wor n r ocker arms
- Br oke n or weak v alve spri ngs
- Wor n c amshaf t lobes.
² Check the intake and exhaust manifolds for casting flash.
Table 3-12. Symptom Diagnosis
Checks Action