Service Manual

SECTION 3 - CHASSIS & TURNTABLE
3121202 – JLG Lift – 3-117
Hesitation, Sag, Stumble
DEFINITION: The vehicle has a momentary lack of response when depressing the accelerator. The condition can occur at any vehicle speed. The condi-
tion may cause the engine to stall if it's severe enough.
Preliminary Checks Refer to Important Preliminary Checks.
Fuel System Checks
² Check the fuel pressure. Refer to LPG Fuel System Diagnosis.
² Check for low fuel pressure during a moderate or full throttle acceleration. If the fuel pressure drops below specifi-
cation, there is possibly a faulty low pressure regulator or a restriction in the fuel system.
² Check the Manifold Absolute Pressure (MAP) sensor response and accuracy.
² Check LPL electrical connection
² Check the mixer air valve for sticking or binding.
² Check the mixer module assembly for proper installation and leakage.
² Check the EPR electrical connections.
Ignition System Checks
Note: LPG being a gaseous fuel requires higher secondary ignition system voltages for the equivalent gasoline oper-
ating conditions. If a problem is reported on LPG and not gasoline, do not discount the possibility of a LPG only igni-
tion system failure and test the system accordingly.
² Check for the proper ignition voltage output with J 26792 or the equivalent.
² Verify that the spark plugs are correct for use with LPG (R42LTS)
² Check for faulty spark plug wires
² Check for fouled spark plugs.
Additional Check
² Check for manifold vacuum or air induction system leaks
² Check the generator output voltage.
Backfire
DEFINITION: The fuel ignites in the intake manifold, or in the exhaust system, making a loud popping noise.
Preliminary Check ² Refer to Important Preliminary Checks.
Ignition System Checks
Important! LPG, being a gaseous fuel, requires higher secondary ignition system voltages for the equivalent
gasoline operating conditions. The ignition system must be maintained in peak condition to prevent backfire.
² Check for the proper ignition coil output voltage using the spark tester J26792 or the equivalent.
² Check the spark plug wires by connecting an ohmmeter to the ends of each wire in question. If the meter reads over
30,000 ohms, replace the wires.
² Check the connection at each ignition coil.
² Check for deteriorated spark plug wire insulation.
² Check the spark plugs. The correct spark plugs for LPG are (R42LTS)
² Remove the plugs and inspect them for the following conditions:
- Wet plugs
- Cr ack s
- Wea r
- Improper gap
- Burned electrodes
- Heav y deposits
Engine Mechanical Check
Important! The LPG Fuel system works on a fumigation principle of fuel introduction and is more sensitive to intake
manifold leakage than a gasoline fuel supply system.
² Check the engine for the following:
- Imprope r va lve tim ing
- Engin e co mpressio n
- Manif old vacuum le aks
- Int ake manifold ga ske ts
- Stick ing or leakin g valves
- Exh aus t system lea kag e
² Check the intake and exhaust system for casting flash or other restrictions.
Fuel System Checks ² Perform a fuel system diagnosis. Refer to LPG Fuel System Diagnosis.
Table 3-12. Symptom Diagnosis
Checks Action