Service Manual Manual

SECTION 3 - CHASSIS & TURNTABLE

3120840 – JLG Lift – 3-41

3.9 STEER ADJUSTMENTS (S MODELS)

NOTE: Spindles do not stop on cylinder stroke. Adjust steer-

ing stops as follows: Adjust item #1 to achieve 44°

inside turn angles. Steer full left and adjust RH item

#2 to contact axle. Steer full right and adjust LH item

#2 to contact axle. (2WS/2WD)

Spindles do not stop on cylinder stroke. Adjust steer-

ing stops as follows: Adjust item #1 to achieve 39°

inside turn angles. Steer full left and adjust RH item

#2 to contact axle. Steer full right and adjust LH item

#2 to contact axle. (2WS/4WD)

3.10 SWING HUB

Adjustment Procedures

NOTE: The swing bearing high spot is usually marked by

colored paint.

1. Ensure swing drive is located on bearing gear max

eccentric tooth (high spot).

2. With mounting free to slide, shim between pinion

and bearing gear teeth to achieve .008 - .012 back-

lash.

3. Install a pry bar into hole in turntable base plate and

pry swing hub back tight against shim and bearing.

4. Torque bolts according to the torque chart in Section

Figure 3-24. Steer Adjustments