Service Manual User guide

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS

3121322 – JLG Lift – 3-23

Pressure Filter

Removal:

1. Disconnect hose(s) from the Pressure Filter (1).

2. Loosen and remove the four Capscrews (2) and

Lockwashers (3).

3. Remove the Pressure Filter.

Installation:

1. Align the pressure filter so that the screw holes

match up with the screw holes on the holding

bracket.

NOTE: Be sure arrow on top of filter points towards the

hydraulic tank.

2. Insert the four Lockwashers and Capscrews into the

holes and tighten.

3. Reconnect any hose(s) disconnected during

removal.

2, 3

1. Pressure Filter 2. Capscrew, M10 x 20mm 3. Lockwasher, M10

Figure 3-21. Pressure Filter Removal