User Manual

Electrical System
9.48
L2906H, 2906H, 3507H, 619A, 723A, 29.6LP, 29.6, 35.7
9.16.5 500 Hour - LSI CAN SYSTEM CHECK
1. Start machine
2. Press the “C” and “OK” buttons simultaneously on
the keypad or the analyzer.
3. Go to “ACCESS LEVEL 2 or 1” and press “OK”.
4. Enter the proper access code and press “OK”.
5. Go to “OPERATOR TOOLS” menu, press “OK”.
6. Scroll to “LSI_CAN SYSTEM CHECK”.
7. “PERFORM LSI_CAN SYSTEM CHECK?”, use the
arrow keys to change “NO” to “YES”.
8. Follow the screen instructions as follows:
a. “Remove Weights and Attachments”, press “OK”.
b. “TELESCOPE IN and FULLY LIFT UP”, press
“OK”.
c. “STOP, WAIT ONE MINUTE”, press “OK”.
d. “PRESS ENTER TO START TEST”
e. “PASS or “FAIL”, press “ESC”. Must receive a
“PASS”.
f. “LSI CAN SYSTEM CHECK”, press “ESC” to
return to menu.
9. Cycle power.Turn machine OFF - ON.
10. Install the previously removed carriage assembly.
9.17 HAND HELD ANALYZER
The hand held analyzer can be used in place of the cab
display panel.
1. Cable Connector.
2. Analyzer Display Screen.
3. Escape Key: To return home or access previous
menu.
4. Enter Key: Stores and selects Top Level, Sub Level
and Items Menus.
5. Up/Down Arrow Keys: Change adjustable values.
6. Left and Right Arrow Keys: Used to move between
Top Level, Sub Levels and Item Menus.
9.17.1 Analyzer Usage
Help messages can be viewed using the Analyzer
(P/N 1001103758). The Help messages can be accessed
by pressing the EN TER key while viewi ng the current
Help message. The Help message shall be
EVERYTHING OK when no fault is present. The Analyzer
cable plugs into the XQ connector of the PCB board
located beside the operator’s seat.
For more information, contact the local JLG dealer.
MZ6040
1
2
3
5
4
6