User Manual

Electrical System
9.52
L2906H, 2906H, 3507H, 619A, 723A, 29.6LP, 29.6, 35.7
9.18.2 Fault Code Table
Message Fault
Code
Indicators Other Actions Taken Tri gge r for Fault Latch Until
HELP COMMENT 00XXX
EVERYTHING OK 001 The system detects no problems
exist.
POWER UP 21XXX
POWER CYCLE 211 Power was cycled ON.
FUNCTION ENABLE
INPUTS – INVALID
SIGNAL STATES
214 1 Ignore and inhibit all function
requests from the platform station.
Output J2-19 Function Enable
Relay of the platf orm module will be
deactivated.
Output J2-26 Engage Starter will
be deactivated and inhibited fr om
the platform.
If both J7-15 of the UGM and J7-8
of the platform module are
simultaneously HIGH or LOW for a
period of 1 second after the
Function Enable Relay power-up
check have been successfully
completed or J7-15 is HIGH and
J7-8 is LOW after the Function
Enable Relay power-up check have
been successfully complet ed and
the PLATFORM STATION is active
and a valid PLATFORM MOD E
exists.
Power cyc led.
JOYSTICK AXES
NOT IN NEUTRAL
POSITIO N AT
POWER UP
215 1 Ignore command signals from the
joystick regarding the X axis and Y
axis.
At system power-up, if the one of
the two axes are not in the neutral
position, the UGM will report and
lo g a “JOYSTI CK AXES NOT IN
NEUTRAL POSITION AT
POWER-UP” fault.
A CAN
message is
received
indicating the
X ax is an d Y
axis are in the
neutral
position.
JOYSTICK ROLLER
NOT IN NEUTRAL
POSITIO N AT
POWER UP
216 1 Ignore command signals from the
joystick regarding the roller.
At system power-up, if the roller is
not in the neutral posit ion on JLG
models only.
A CAN
message is
received
indicating the
roller is in the
neutral
position.
JOYSTICK S1
BUTTON ACTIVE A T
POWER UP
217 1 Ignore command signals from the
joystick S1 button that was active
during the power-up.
At system power-up, if the S1 button
is activated.
A CAN
message is
received
indicating the
joystick S1
button is not
activated.
JOYSTICK S2
BUTTON ACTIVE A T
POWER UP
218 1 Ignore command signals from the
joystick S2 button that was active
during the power-up.
At system power-up, if the S2 button
is activated on JLG models only.
A CAN
message is
received
indicating the
joystick S2
button is not
activated.