User Manual

9.85
L2906H, 2906H, 3507H, 619A, 723A, 29.6LP, 29.6, 35.7
Electrical System
LOW ENG I NE OI L
PRESSURE
WARNING
4318 1, 2, 9 N/A The ECM detects the engine oil
pressure is getting low , the ECM will
transmit a J1939 CAN bus DM1
message, or use the J1939 Transfer
Protocol in the event multiple
engine faults exist, on CAN1 to
communicate low engine oil
pressure (SPN:FM I 100:17 or
100:18).
Power cycled.
LOW ENG I NE OI L
PRESSURE
CRITICAL
4319 1, 2, 3, 9 N/A MECHANICAL: The UGM detects
input J12-8 Engine Oil Pressure is
LOW for 3 seconds and an ENGINE
RUNNING state exists for a period
of 5 seconds.
ELECTRONIC: The engine oil
pressure reaches its critical low oil
pressure value, which is based on
engine speed, the ECM will transmit
a J1939 CAN bus DM1 message, or
use the J1939 Transfer Protocol in
the event multiple engine faults
exist, on CAN1 at a rate of 1 second
to communicate low engine oil
pressure (SPN:FM I 100:1).
Power cycled.
ALTERNATOR
CHARGING
FAILURE
4320 1, 2, 10 N/A Once an ENGINE RUNNING state
exists for a period of 3 seconds or
more, J4-7 Alternator D+ input will
be LOW for a period of 500ms.
J4-7
Alternator D+
is continu-
ously HIGH
for a period of
3 seconds.
AIR FILTER
RESTRICTION
4321 1, 2, 7 N/A J1-34 Air Filter Restriction input is
LOW and an ENGINE RUNNING
state exists for a period of 3
seconds or more or 10 seconds
after a syst em power up.
J1-34 Air
Filter
Restriction
input is HIGH
for 1 second.
LOSS OF ENGINE
SPEED SIGNAL
4322 1, 2 Deactivate J2-26 Engage Starter.
Ignore the above-mentioned
interlock for disabling the
Continuous Auxiliary Hydraulics
function when engine speed is 600
RPM.
Ignore the prevent engine stall
logic.
MECHANICAL: J4-7 Alternator D+
is HIGH and J12-8 is HIGH and no
impulses are received at J1-16
Engine Speed.
ELECTRONIC: The T CM or ECM
will report the fault using J1939
CAN protocol to the UGM.
Power cycled.
CONFLICTING
OPERATING
ENGIN E STATE
4324 1, 2 N/A J4-8 Engine Start has been
engaged during the active power
cycle, an ENGINE STOPPED
condition exists, and one of the
three ENGINE RUNNING
conditions is true
Power cycled.
BATTERY SUPPLY 44X XX
Message Fault
Code
Indicators Other Actions Taken Trigger for Fault Latch Until