User Manual

Electrical System
9.88
L2906H, 2906H, 3507H, 619A, 723A, 29.6LP, 29.6, 35.7
INVALID
TRANSMISSION
CONFIGURATION
466 1 Deactivate output J1-20
Transmi ssion D / 2 Coil.
Deactivate output J1-7
Transmission E / 1 Coil.
Deactivate output J2-33
Transmission A / Forward Coil.
Deactivate output J2-32
Transmission B / Reverse Coil.
Deactivate output J1-10
Transmission C Coil.
Deactivate output J2-5 Frame
Leveling Right Valve.
Deactivate output J2-7 Frame
Leveling Left Valve.
Deactivate output J2-3 Right
Stabilizer Up Valve.
Deactivate output J2-15 Right
Stabilizer Down V alve.
Deactivate output J2-10 Left
Stabilizer Up Valve.
Deactivate output J2-21 Left
Stabilizer Down V alve.
Deactivate output J2-13 Dump
Valve.
Deactivate output J1-3 Stabilizer
and Frame Level Speed Valve
(if applicable).
Deactivate output J2-11 Main Lift
Up Valve.
Deactivate output J2-22 Main Lift
Down Valve.
Deactivate output J2-35 Main
Telescope Out Valve.
Deactivate output J2-34 Main
Te lescope In Valve.
Deactivate output J2-8 Fork Tilt Up
Valve.
Deactivate output J2-19 Fork Tilt
Down Valve.
Deactivate output J2-9 Auxiliary
Hydraulics 1 Valve.
Deactivate output J2-20 Auxiliary
Hydraulics 2 Valve.
J4-22 3rd
Gear or J4-23 4th Gear
are LOW and a TRANSMISSION
selection of HYDROSTATIC is
configured.
The
configuration
is corrected
and power is
cycled.
TRANSMISSION
TROUBLE CODE:
(SPN):(FMI)
467 1 (TCM wi ll determine the proper
action to ta ke.)
Flash the current drive direction
and gear selection on the cabin’s
display.
The TCM detects a fault condition
(not defined in this SRD).
Power cycled
VEHICLE SPEED
SENSOR – NOT
RESPONDING
468 1 Broadcast a proprietary B CAN
message on CAN1 to display a
value of ‘99’ on the cabin’s LCD
display.
Disable the drive direction interlock
and allow drive direction to be
changed at any point in time.
Boom Ride feature will be inhibited
if configured.
VEHICLE SPEED is configured i n
the MACHINE SETUP menu and
the transmission is not in neutral
and the service brake is not
engaged and the park brake is not
engaged and Engine RPM is 1200
RPM and no VEHICLE SPEE D
signal is measured for a period 3
seconds or more.
Power cyc led.
Message Fault
Code
Indicators Other Actions Taken Tri gge r for Fault Latch Until