User Manual

Electrical System
9.90
L2906H, 2906H, 3507H, 619A, 723A, 29.6LP, 29.6, 35.7
CANBUS F AILURE –
CABIN JOYSTICK
6617 1 Disregard any CAN messages with
the cabin joystick source
addresses.
Deactivate and inhibit all hydraulic
functions.
The UGM does not detect the
cabin’s joystick on the CAN bus for
a period of 250msec and an
ENGINE STOPPED or ENGINE
RUNNING state exists for a period
of one second.
V alid CAN bus
communic a -
tion is
re-estab-
lished with the
joystick.
CANBUS F AILURE –
CABIN DISPLAY
6618 1 The UGM does not detect the
cabin’s display on the CAN bus.
Power cyc led.
CANBUS F AILURE –
UNKNOWN
TROUBLE CODE:
(SPN):(FMI)
6619 1 N/A The UGM has detected an unknown
module reporting a DM1 or transfer
protocol message.
Power cyc led.
CANBUS F AILURE –
BOOM ANGLE
SENSOR
6621 1 Display the fixed boom angle value
of ‘99’ on the operator’s cabin
display.
Temporarily assign a fixed boom
angle value of 99×.
Disallow boom angle sensor
calibra tio n ( “B OOM ANGLE:
CALIBRATION FAIL”).
Ignore any hydraulic function
requests from the platform station.
Deactivate and inhibit the Lift Up
output if the platform is detected as
attached or PLATFO RM MODE is
the current active mode; otherwise,
derate the MAX LIFT UP in the
PERSONALITIES menu screen by
the LIFT UP DERATE value in the
Constant Data tables.
The UGM or platform module has
lost communications wit h the Boom
Angle Sensor.
Power cyc led.
CANBUS FAILURE -
TCU MODULE
6622 1 CAN Communicati ons has been
lost with the TCU module for 30
seconds or more. Only reported if
the tel e matic s m a ch i n e
configuration digit is enabled.
V alid CAN bus
communic a -
tions is
re-estab-
lished with the
telematics
module
CANBUS FAILURE -
GATEWAY MODULE
6623 1 CAN Communicati ons has been
lost with the gateway module for 30
seconds or more. Only reported if
the tel e matic s m a ch i n e
configuration digit is enabled.
V alid CAN bus
communic a -
tions is
re-estab-
lished with the
gateway
module
CANBUS FAILURE -
TELEMATICS CAN-
BUS LOA D ING TOO
HIGH
6629 1 If this fault has been detected, the
CANBUS FAILURE TCU
COMUNICATIONS LOST fault will
be suppressed.
Power cyc led.
Message Fault
Code
Indicators Other Actions Taken Tri gge r for Fault Latch Until