Service Manual Owner's manual
Table Of Contents
- Section 1. Specifications
- Section 2. General
- Section 3. Chassis & Turntable
- 3.1 Tires & Wheels
- 3.2 Wheel Drive Assembly, 2WD
- 3.3 Drive Motor - 2WD (Prior to S/N 83331)
- 3.4 Drive Motor (S/N 83331 to Present)
- 3.5 Torque Hub
- 3.6 Wheel Drive Assembly, 4WD
- 3.7 Torque Hub (4WD Machines W/ Integral Brake)
- Roll, Leak and Brake Testing
- Tightening and Torquing Bolts
- Main Disassembly
- Input Carrier Disassembly
- Output Carrier Disassembly
- Housing-Spindle Disassembly
- Spindle-Brake Disassembly
- Input Carrier Sub-Assembly
- Output Carrier Sub-Assembly
- Spindle-Brake Sub-Assembly
- Housing-Spindle Sub-Assembly
- DW2B Integral Brake Check
- Main Assembly
- 3.8 Drive Brake, 2WD - Mico (Prior to S/N 83331)
- 3.9 Re-Aligning torque hub input coupling
- 3.10 Oscillating Axle Bleeding Procedure and Lockout Test
- 3.11 Swing Drive Hub
- 3.12 Swing Brake - Mico (Prior to S/N 66417)
- 3.13 Swing Motor (Prior to S/N 66417)
- 3.14 Swing Motor (S/N 66417 to Present)
- 3.15 Procedure For Setting Gear Backlash
- 3.16 Swing Bearing
- 3.17 Rotary Coupling
- 3.18 Generator
- 3.19 Ford EFI Engine
- 3.20 Deutz EMR 2 (S/N 85332 to Present)
- 3.21 GM Engine General Maintenance
- 3.22 GM Engine Dual Fuel System
- Fuel Filter
- Electric Lock Off
- EPR Assembly
- Low Pressure Regulator (LPR)
- Air Fuel Mixer
- Electronic Throttle Control (ETC)
- Engine Control Module
- Heated Exhaust Gas Oxygen Sensor
- Gasoline Multi Point Fuel Injection System (MPFI)
- Gasoline Fuel Pump
- Gasoline Pressure And Temperature Sensor Manifold
- Fuel Filter
- Fuel Injector Rail
- Fuel Injector
- 3.23 GM Engine Fuel System Repair
- Propane Fuel System Pressure Relief
- Propane Fuel System Leak Test
- Propane Fuel Filter Replacement
- Electronic Pressure Regulator (EPR) Assembly Replacement
- Temperature Manifold Absolute Pressure (TMAP) Sensor
- Electronic Throttle Control Replacement
- Mixer Replacement
- Coolant Hose Replacement
- Vapor Hose Replacement
- Engine Control Module Replacement
- Heated Exhaust Gas Oxygen Sensor Replacement
- 3.24 GM Engine LPG Fuel System Diagnosis
- Section 4. Boom & Platform
- Section 5. Hydraulics
- Section 6. JLG Control System
- Section 7. Basic Electrical information & schematics
SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS
3121139 – JLG Lift – 7-11
J7
HEADLIGHTS
AND
TAILLIGHTS
SPEED
PICKUP
(DEUTZ
ENGINE)
RECEPTACLE
AT PLATFORM
(OPTIONAL)
J1
J2
J3
J4
GROUND
CONTROL
BOX
TO
ANALYZER
FUEL ON
SOLENOID
(DEUTZ ENGINE)
FUEL
PUMP
(CATERPILLAR
ENGINE)
THROTTLE
AUTUATOR
(CATERPILLAR
ENGINE)
THROTTLE
CONTROLLER
(FORD ENGINE)
BOOM
TRANSPORT
LENGTH
SWITCH
BOOM
CAPACITY
ANGLE
SWITCH
BOOM
PROX.
SWITCH
BOOM
ELEVATION
SWITCH
BEACON
FUEL
PUMP
(FORD
ENGINE)
PUMP
GROUND
CONTROL
BOX
BOOM
CAPACITY LENGTH
SWITCH
ALTERNATOR
(FORD ENGINE)
DUAL
SELECT
VALVE
TO
PLATFORM
AUX.
POWER
SOLENOID
S/N 73347 TO
PRESENT
PRIOR TO
S/N 73347
LP
CONVERTOR
(FORD DUAL
FUEL)
GENERATOR
RELAY ON
ENGINE TRAY
GENERATOR
BOX
GENERATOR
Figure 7-19. Electrical Components Installation (Prior to S/N 0300085332) - Sheet 2