Parts Manual User guide

2-4 3120800
SECTION 2 TURNTABLE
S
E
C
T
I
O
N
2
T
U
R
N
T
A
B
L
E
23 4300034 Stud (Not Shown) 1
24 to25 Not Used
26 3311601 Nut 3/8"-16NC 1
27 Not Used
28 0960562
Bushing, Self-Aligning (Part of Turntable
Weldment)
2
29 1120192 Cap, Boom Pivot 2
30 0681808 Bolt 1/2"-13NC x 1" (Grade 8) 4
31 3952016 Setscrew 5/8"-11NC x 2" 2
32 to 33 Not Used
34 3312002 Nut, Jam 5/8"-11NC 2
35 2160006 Fitting, Grease 2
36 to 50 Not Used
51 Boom Assembly Options: 1
Australian Spec
0800662 80HX Built Prior To May 1992
0800807 80HX Built May 1992
0800814 80HX With Chip Covers
0801016 80HX With Inverted Power Track
0800810 80HX+6 Built May 1992 To Present
0800816 80HX+6 With Chip Covers
0801151 80HX (Modified)
CE Spec
0800677 80HX Built Prior To May 1992
0800809 80HX Built May 1992 To Present
0800815 80HX With Chip Covers
0800663 80HX+6 Built Prior To May 1992
0800681 80HX+6 Built Prior To May 1992
0800811 80HX+6 Built May 1992 To Present
0800817 80HX+6 With Chip Covers
52 Pin Options (Boom Pivot): 1
4040129 Australian Spec 80HX
3421815 Australian Spec 80HX with Inverted Power Track
3421815 Australian Spec 80HX+6 Built Prior To May 1992
4040129
Australian Spec 80HX+6 Built May 1992 to
Present
3421815 CE Spec 80HX
4040129 CE Spec 80HX+6
4040129 CE Spec with Chip Covers
0237546 BEARING LUBE INSTALLATION Ref. D
101 2160002 Fitting, Grease 3
102 2220124 Fitting 3
103 to 104 Not Used
105 2750528 Hose (60" Length) 1
106 2220063 Fitting, 90º 2
107 2180344 Fitting, Bulkhead 3
108 2220063 Fitting, 90° 1
109 2752427 Hose 2
FIGURE 2-1. BOOM, TURNTABLE AND BEARING LUBE INSTALLATION (CONTINUED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.