Parts Manual Instruction Manual

7-12 800S 860SJ 3121140
SECTION 7 ELECTRICAL
463 Not Used
464 4460887 1 Terminal, Molex
465 to 467 Not Used
468 3730120 1 Resistor Assembly (SN 0300073347 to SN 0300085332)
468A 4460978 1 Receptacle, Male - 2 Position
468B 4460979 2 Pin, Male
468C 4460458 2 Seal, Terminal
468D 3730121 1 Resistor
Ref GROUND CONTROL BOX WIRING DIAGRAM
4933201 Ref Deutz Engine 6/I
4933200 Ref Ford Engine 5/G
4933292 Ref Caterpillar Engine 2/C
501 2920129 AR Bulb, Light
502 to 506 Not Used
505 2400065 1 Fuse, 30Amp
506 2400066 1 Fuse, Holder
507 to 509 Not Used
510 4460708 2 Receptacle, Female - 15 Position
4460226 13 Socket, Female
511 4922771 1 Harness, Angle Sensor
1060902 9.5ft/2.9m Cable - 18/2
511A 4460226 4 Socket, Female
511B 4460424 1 Receptacle, Female - 2 Position
Ref STANDARD HARNESS COMPONENTS
601 1 Ford Engine ECM Harness (For replacement parts refer to Ford
engine dealer (Ford Engine Machines) Options:
7023681 1 Prior to SN 0300079612 (was p/n 7023663)
7027403 1 SN 0300079612 to SN 0300085332
602 7022134 1 Ford Engine Fuel Pump Harness
603 See Note 1 Pump Harness (Note: Not Available for Purchase.)
7007497 2 Plug (Pump)
603A 7007498 1 Plug (Valve Harness)
604 2 Switch, Tilt Sensor Options (Includes Tilt Sensor):
Use 4360544 Prior to SN 0300066741(was p/n 4360503)
Use 4360544 SN 0300066741 to SN 0300075873 (was p/n 4360528)
4360544 SN 0300075873 to SN 0300085332
604A 4460911 2 Plug, Male Deutsch - 3 Position
4460918 6 Socket, Female
4460912 2 Lock, Wedge
605 See Note 1 Controller Harness Assembly (Lift and Swing) (Note: Not
Available for Purchase.)
605A 7022819 1 Connector, Male - 9 Position
7022820 8 Socket, Female
FIGURE 7-2. HARNESS COMPONENTS INSTALLATION (WITHOUT UGM) (PRIOR TO SN
0300085332) (CONTINUED)
ITEM # PART NUMBER QTY. DESCRIPTION REV.