Operator Manual Owner's manual

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION

3-20 – JLG Lift – 3121135

StockPicking Platform Operation

The stockpicking platform is available in two (2) versions.

• Fixed side-rail version

• Folding side-rail version

CAUTION

THE STOCKPICKER PLATFORM ALLOWS THE MACHINE TO BE

OPERATED IN AN OPEN RAIL CONFIGURATION (SEE ILLUSTRA-

TION).

CE SPECIFICATION MACHINES:

THE OPERATOR MUST WEAR A FULL BODY HARNESS

EQUIPPED WITH A LANYARD SHORT ENOUGH TO PREVENT A

FALL FROM THE PLATFORM. THE LANYARD MUST BE

ATTACHED TO THE AUTHROIZED LANYARD POINT. ALSO, JLG

RECOMMENDS THAT CE SPECIFICATION MACHINES EQUIPPED

WITH THE STOCKPICKER PLATFORM ARE ONLY TO BE USED

FOR STOCKPICKING APPLICATIONS.

NON-CE UNITS:

THE OPERATOR MUST WEAR A FULL BODY HARNESS WITH A

LANYARD (MAX. 6 FT. (1M) ATTACHED TO THE AUTHORIZED

LANYARD POINT OR A BODY BELT EQUIPPED WITH A LANYARD

SHORT ENOUGH TO PREVENT A FALL FROM THE PLATFORM.

WHILE OPERATING THE MACHINE IN THE OPEN RAIL CONFIGU-

RATION, ALWAYS OPERATE THE MACHINE FROM THE REAR OF

THE PLATFORM WITH THE MID-GATE CLOSED AND THE PLAT-

FORM CONTROL CONSOLE ATTACHED TO THE FIXED PORTION

OF THE GUARDRAIL.

STOCKPICKER PLATFORM

(WITH FOLDING SIDE-RAILS) (DVSP)

Model Max. Capacity

15DVSP 500 lb. (230 kg)

20DVSP 400 lb. (180 kg)

1. Primary Entrance/Exit Gate 4. Platform Control Console

2. Primary Entrance Latch 5. Mid-Gate

3. Lanyard Attach Point - 6. Gate Release/Lock Pins

(on side of mast) 7. Secondary Exit Gate

STOCKPICKER PLATFORM

(OPEN RAIL CONFIGURATION) (DVSP)

1. Platform Mid-Gate (enter rear of platform and close mid-gate

when driving with front rails open).

2. Open Rail Configuration work area. (See previous Caution about

fall protection requirements).

3. Platform Control Console attached to fixed side-rail in the rear of

the platform.