User Manual

SECTION 1 - SPECIFICATIONS
3120884 – JLG Lift – 1-7
Table 1-8. Lubrication Chart
Components
Number/Type
Lube Points
Capacity Lube
Interval Hours
Comments
3 Months
150 hrs
6 Months
300 hrs
1 Year
600 hrs
2 Years
1200 hrs
Lubrication
1
Swing Bearing
1 Grease Fitting or by
brush
A/R MPG X More frequent lubrication intervals may be
required
2
Swing Bearing /
Worm Gear T eeth*
Spray On A/R Mobiltac
375NC
X More frequent lubrication intervals may be
required.
3
Hydraulic Fluid (Oil)
Fill Cap 15 liters (tank) HO X Check oil every 10 hours of operation.
Change oil every 1200 hours of operation.
4
Hydraulic Filter
N/A N/A N/A X Replace filter element after first 50 hours and
every 300 hours thereafter .**
5
Wheel Drive Hub
Fill Plug/Half Full 0.5 liter (1/2 Full) EPGL X Check oil level at side plug on hub daily .
Change after first 150 hours then every 1200
hours of operation.
6
Wheel Bearing
Repack A/R MPG X
7
Spindles/Bushing
N/A A/R LL At Spindle/Bushing Replacement Coat I.D. of bushings prior to installing king
pins.
8
Boom Pivot Pins/
Bushing
N/A A/R LL At boom pivot pins/bushing replacement Coat I.D. of bushings prior to installing pins.
9
Engine
Fill Cap Refer to Engine
Manual
EO Check daily . Change in accordance with
engine manual.
NOTES: KEY TO LUBRICANTS
Lubrication intervals are based on machine operation under normal conditions. For machines used in multi shift operations and/or exposed to hostile
environments or conditions, lubrication frequencies must be increased accordingly .
EO
EPGL
HO
MPG
LL
Engine Oil
Extreme Pressure Gear Lube
Hydraulic Fluid (Mobil DTE-1 1M)
Multi-Purpose Grease
Synthetic Lithium Lubricant
* If necessary install grease fittings into worm gear housing and grease bearings.
DO NOT OVERGREASE BEARINGS. OVERGREASING BEARINGS WILL RESULT IN
BLOWING OUTER SEAL IN HOUSING.
** Under certain conditions, it ma y be necessary to replace the hydraulic filter on a more frequent basis. A common symptom of a dirty filter is sluggish-
ness experienced in hydraulic functions.