User Manual

SECTION 2 - PROCEDURES
2-76 – JLG Lift – 3120884
2.26 PREVENTIVE MAINTENANCE AND
INSPECTION SCHEDULE
The preventive maintenance and inspection checks are
listed and defined in the following table. This table is
divided int o two basic part s, the "AREA" t o be inspect ed,
and the "INTERVAL" at wh ich the insp ection is to t ake
place. Under the "AREA" of the table, the various systems
along with components that make up that system are
listed. The "INTERVAL" portion of the table is divided into
five columns representing the various inspection time
periods. The numbers listed within the interval column
represent the applicable inspection code for which that
component is to be checked.
The checks and services listed in this schedule are not
intended t o replac e any loca l or region al re gulations that
may pertain to this type of equipment nor should the list s
be considered as all inclusive. Variances in interval ti mes
may occur due to climate and/or conditions and depend-
ing on the location and use of the machine.
JLG Industries requires that a complete annual inspection
be performed in accordance with the "Annual Machine
Inspection Report" form. Forms are supplied with each
new machine and are also available from JLG Customer
Service. Forms must be completed and returned to JLG
Industries.
JLG INDUSTRIES REQUIRES THAT A COMPLETE ANNUAL
INSPECTION BE PERFORMED IN ACCORDANCE WITH THE
"ANNUAL MACHINE INSPECTION REPORT" FORM.
This machine requires periodic safety and maintenance
inspections by a JLG Dealer. A decal located on the turn-
table affords a place to record (stamp) inspection da tes.
Notify dealer if inspection is overdue.
The inspection and maintenance code number s are as fol-
lows:
1. Check for proper and secure installation.
2. Check for visible damage and legibility.
3. Check for proper fluid level.
4. Check for any structural damage; cracked or broken
welds; bent or warped surfaces.
5. Check for leakage.
6. Check for presence of excessive dirt or foreign
material.
7. Check for proper operation and freedom of move-
ment.
8. Check for excessive wear or damage.
9. Check for proper tightness and adjustment.
10. Drain, clean and refill.
11. Check for proper operation while engine is runn ing.
12. Check for proper lubrication.
13. Check for evidence of scratches, nicks or rust and
for straightness of rod.
14. Check for condition of element; replace as neces-
sary.
15. Check for proper inflation.
16. Clean or replace suct ion screen.
17. Drain and clea n.
* To be performed quart e rly.
** Inspection and Main tenance Code 10, 12, 16 to per-
formed every two years.