Operator Manual Owner's manual

Form No. 20140, Issued 3/03

Transformer Series Work Platform Manual

P5.2

9. Attach the electric harness lines as

shown to the front of boom.

7. Always turn off the machine before

performing the next several steps.

NOTE!

10. Attach the hydraulic lines to the

side of boom as shown.

8. Press the decompression valve

located in cab, this takes the

pressure out of the auxiliary

hydraulic lines located on boom

head.

When hooking up the Transformer

Series platform, the hydraulic

hoses are run through the Quick

Switch™. Pull these hoses and

electrical cables back to prevent

pinching when attaching and

hooking up hydraulic hoses to the

front of the boom.

Important Notice !

This machine has been equipped with a serial number specific Transformer Series

Personnel Work Platform. Do not exchange transformer platforms between

machines. Doing so will require calibration changes to the controller that must be

performed by a qualified service technician. This platform assembly is designed

soley for use with the

Transformer Model Machines only.

WORK PLATFORM INSTALLATION