Product Manual

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
/L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
L'appareil ne doit pas produire de brouillage;
L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement./
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure. Users can obtain Canadian information on RF exposure
and compliance.
/Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS
102 etla conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne
surl'exposition et la conformité de rf./
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
/Cet émetteur ne doit pas être placé au même endroit ou fonctionner en conjonction avec une autre
antenne ou un autre émetteur. Cet équipement doit être installé et utilisé à une distance minimale
de 20 cm entre l’émetteur de radiofréquences et votre corps./
Safety Warning
Read this product manual thoroughly before attempting to use this product. Store the product
manual in a safe location so it may be referenced at any time.
The product can be powered on and off by plugging and unplugging the power cord. The socket
should be located near the product and easily accessible.
Do not block the air inlet or outlet of the product with any objects when it is projecting an image.
Doing so may result in excessive internal temperatures and damage to the projector.
Do not hit or drop the product from a significant height.
If you encounter an issue with the product, do not attempt to disassemble it without authorization.
Contact professional after-sales personnel to resolve the issue.
If you need to perform repairs on the product, wear a laser face shield with an OD (optical density)
of ≥ 4 and a wavelength range of 440-660nm.