User Manual

Operation Manual of Wireless NVR Kit
8
3.Installation and Connection
3.1 Installation Precautions
Note the following when installing and using：
1、In order to extend the life of the machine, the machine should be kept away from water, high temperature and dusty
environment, and placed in a well-ventilated place.
2、Please use SATA hard drives, USB devices, and mouse devices purchased through regular channels.
3、Before use, please make sure that the network HD recorder is properly grounded and the power supply cannot exceed the
normal operating voltage range of the power supply.
3.2 Preparation Before Installation
1、Determine where to place the NVR
It is recommended to put the NVR in the center of the surveillance area, and avoid obstacles between the IPC (wireless
camera) installation location and the NVR. When 4 channels of video are connected at the same time, when there is no
obstacle between NVR and IPC, IPC is placed in the spherical coverage area with NVR as the center of the sphere and a
radius of 60 meters. 30 meters, two walls reduce the radius to 15 meters
2、Connection steps
Install the hard disk to the NVR, as shown in the figure, after the installation is complete, first connect the NVR to the
mouse and the display, turn on the power, and connect the power to the IPC.
(1) Using a screwdriver, remove the top cover;
(2) Install the hard disk data cable and power cable, and tighten the screws;