User Manual

Operation Manual of Wireless NVR Kit
9
(3) Confirm that the wireless NVR package is working properly
The NVR is connected to the monitor, and all supporting IPCs are placed around the NVR. Can be installed to a
predetermined location.
3.3 Camera is Placed in a Preset Position
1、Install the wireless camera to the preset position within the effective coverage of the wireless signal and provide 12V
power supply;
2、When the wireless camera is powered on for about 1 minute, you can see the video on the NVR monitor;
3、If there is no image, it indicates that the distance is too far, the distance needs to be shortened.
NVR antenna transmits signals to the surroundings. The NVR and IPC antennas are at the same height and parallel to each
other. The best effect is if the antennas are not at the same height. The IPC antenna should be tangent to the spherical
surface with the NVR as the center (Figure 6) Point directly to the NVR (Figure 7)
Correctly Misplaced
4.System Function Introduction
4.1 Switch Machine
4.1.1 Boot
Note：
Please confirm that the connected voltage matches the requirements of the hard disk recorder, and ensure that the ground
terminal of the hard disk recorder is well grounded.
When the power supply is abnormal, it will cause the hard disk recorder to not work normally, or even damage the hard