User Manual
Table Of Contents
- Foreword
- 2. Instructions
- 3.Installation and Connection
- 4.System Function Introduction
- 4.1 Switch Machine
- 4.4 IPC Settings
- 5 Mobile P2P Access
- 6.Appendix
Operation Manual of Wireless NVR Kit
14
4、Setting 4: network settings. You can choose to automatically obtain an IP address, manually set the IP address, and
network diagnostic operations. The operation interface is as shown in the figure below. After the operation is completed,
click Next to continue the wizard setup. If you need to return to Setup 3, select the previous step.
5、Setting 5: Hard disk settings. It can display the list of currently existing hard disks, including model, capacity, usage,
status, and format status. If users need to format the hard disk, they can first select the corresponding hard disk, and then
click the format button. After a while, the selected hard disk can be formatted, and the format status of the hard disk will
also be displayed as "formatted". The operation interface is as shown in the figure below. After the operation is completed,
click Finish after the settings are completed to complete all the above settings. If you need to return to Settings 5, select the
previous step. If you click Cancel, the above settings will not take effect.