Spectator Owner's Manual
Table Of Contents
- General remarks
- 1.1. Introduction
- 1.2. Safety instructions
- 1.3. Scope of delivery
- 1.4. Charging the battery
- 1.5. Switching on / off
- 2.1. Product Function Diagram
- 2.2. OPERATION
- 3.1. Minimum systems requirements
- 3.2. Driver Windows 98/ME/XP/VISTA, Linux 2.4.x, MacOS 10.2.x
- 3.3. Log off SPECTATOR under Windows
- 3.4. SPECTATOR format for hard disks
- 3.6 Connect to PC
- 4.1. Warranty conditions
- 4.2. Contact/Service
- 4.3. STATEMENT & CAUTIONS
- 4.4. Technical specifications
8
1.5. Switching on / off
1.5.1. Switching on SPECTATOR
On the right-hand side there is the „ON / OFF” sliding switch by which to switch
on SPECTATOR. In order to avoid switching on the device by mistake the switch
needs to be held in the “ON” position for 2 seconds to activate the device. Make
sure that the battery is sufficiently charged.
1.5.2. Switching off SPECTATOR
In order to switch off the device you again operate the “ON / OFF” sliding switch
on the right-hand side for about 2 seconds. The display will confirm that the
device has been switched off.
The device has an energy saving function that you can activate in the systems
menu or by way of a timing function. With this function the display is switched
off after a pre-selected time. This measure relieves the internal battery and thus
saves energy. In order to use the device again press the “ON/OFF“ sliding switch.