Use and Care Manual

Crossover, Chest, Innerside, Topside
and Underbed Truck Boxes
In the event you need to obtain Replacement Parts, we will need the Model Number of your JOBOX Truck Box. Please locate the
Model Number of your product and list it in the space below.
Model No._______________________________Date Purchased_______________________________
Keys
Your JOBOX Truck Box is shipped with two keys. We have hundreds of different locks and key patterns to fit the locks. The Key Code
for the key to fit the lock(s) for your JOBOX Truck Box is stamped on the key and on the cover of the key entry slot of the lock.
You will need this Key Code to obtain additional or replacement keys. Write the Key Code in the space below for future reference.
Key Code_______________________________
Gas Spring Lid Lifts
Many of our products have one or two Gas Spring Lid lifts to assist with opening and closing the lid.
To obtain a replacement Gas Spring Lid Lifts used on your product, we will need the Model Number that appears on a label on the
barrel of the Gas Spring. Please locate the code on the Gas Spring and write it in the space below for future reference.
Gas Spring Lid Lift Model No._______________________________
To Obtain Keys, Gas Spring Lid Lifts And Other Replacement Parts
Contact our Customer Service Department at 800-643-0084 and Press 1 between the hours of 8:30 AM and 4:30 PM Central Time
Monday – Friday. Or, by email at [e-mail].
To help us serve you, please have the above information available. We will need a street address to send you the item(s) you request.
Orders for Keys, Gas Spring Lid Lifts and other Replacement Parts are normally shipped within two business days.
Prices for Parts do not include shipping charges and are subject to applicable taxes.
You can send a money order or personal check for parts orders. COD shipments not available.
We also accept MasterCard and Visa information only by phone. Do not send Cr
edit Card information by email for your protection.
(see back for more information)
IMPORTANT INFORMATION
Please Read And Save This Form
1. Determine the required distance
between boxes (Fig. A). Drill 9/32˝
diameter holes through the box and
truck rail at front and rear. Fasten at
front and rear using flat washers, lock
nuts, and 1/4-20 x 1˝ long screws as
shown in Fig. B. Position so that the
screw holes drilled in the truck bed as
mentioned in Step 3 will not interfere with truck frame members,
electrical wiring, hydraulic lines, etc.
NOTE: Be sure boxes are level before drilling any further holes!
2. Position mounting brackets against the box at the front and rear
inboard corners. Using the mounting brackets as templates, drill
9/32˝ diameter holes through the box. Fasten the brackets to the
box using 1/4-20 x 1˝ long screws, flat washers, and hex nuts as
shown in Fig. B.
3. Drill 9/32˝ diameter holes through truck bed and fasten brackets
to truck bed using flat washers, hex nuts and 1/4-20 x 1˝ long
screws as shown in Fig. B. Install the flat washer on the top of the
bracket flange and nuts under the truck bed.
4. To install the optional steel shelf, position it in the desired location
inside the box against the back wall. Mark the hole locations and
remove the shelf. Drill 9/32˝ holes in the locations marked. Mount
the shelf using the fasteners provided.
Figure B
Figure A
Topside Box Installation Instructions
10490-395
Rev. 10/04