MINI ELECTRIC SEWING MACHINE OPERATION MANUAL 1
Parts & Accessories Thread Spindle(C) Thread Spool(E) Takeup Lever(D) Bobbin Holder(V) MAIN UNIT Bobbin winder Spool(T) Hand Wheel(K) Needle Clamp Screw(O) Bobbin Spindle(U) Adjusting Screw(Q) On/Off switch(A) Needle Clamp(P) Speed Button(L) Needle(R) Bobbin Compartment(I) Tension Screw(N) Bobbin(S) Battery Compartment(B) (on underside of machine) Thread Gap(H) Presser Foot(F) Bobbin Holder(J) MAIN UNIT (back view) ACCESSORIES Presser Foot Lever(G) Foot Pedal Four Metal Bobbins Needle
GETTING STARTED (Refer to illustrations for locations and configuration of components). AFTER REMOVING THE MACHINE FROM THE PACKING BOX 1. Make certain the on/off switch (A) is in the off position before inserting the batteries. 2. Put 4 AA batteries into the battery compartment (B) on the underside of the machine or insert the power adapter into the DC jack. 3. Press switch (A) to turn on or off.
BOTTOM BOBBIN REPLACEMENT 1. Remove the bobbin compartment cover (I). 2. Place the bobbin with a thread of your choice in the bobbin holder (J) leaving approximately 25cm of thread extended out from the bobbin holder (J). 3. Extend the thread into the thread gap (H). 4. Turn the hand wheel (K) clockwise. The needle will go down, picking up the bobbin thread. Continue to turn the hand wheel until the needle (R) has descended completely and then returned to the highest raised point. 5.
7. Turn the power switch (A) to the on position. 8. Gently guide the fabric to keep the seam straight by pressing lightly down with your finger tips on both sides as it feeds through the presser foot (F). 9. When the seam is finished turn the switch (A) off. 10. Raise the needle (R) above the fabric by turning the hand wheel (K) slightly in a clockwise direction. 11. Raise the presser foot (F) by lifting the presser foot lever (G). 12.
WINDING THE BOBBIN 1. Always remove the bobbin (S) from the bobbin case on the machine before you wind a new bobbin. 2. Place the thread spool (E) on the thread spindle (C) 3. Put the bobbin pin into the hole on the hand wheel and turn it slightly anti-clockwise. 4. Take an empty bobbin and in one hand pull the thread down from the thread spool (E) and thread the loose end through the small hole on the bobbin rim from the inside. 5.