Instruction Manual

51
SETTING INTERNAL TEMPERATURE
Temperature setting of your product has made at the factory in a manner that it is
operated under the most appropriate conditions.
When you run your product at factory set value, you get the best result in terms of both
the performance and energy consumption.
Run your device empty for at least three hours. Therefore, inside of your product will
be cooled down in the best way. It is recommended to place the thermostat in position
4.
WARNING!
Internal temperature of your product can be adjusted between 1°C and 10°C.
Always provide a gap between the top and the product you load for ensuring air
circulation.
CAUTION!
If your product is stored indoors after it has been turned off:
Do not cover it with plastic material. Plastic will cause odor and moisture retention in
your product as it prevents ventilation. Lack of ventilation can result in corrosion.
DEFROSTING
• An evaporator without ice, will always work at high efficiency.
• Water from the evaporator falls onto the drip tray in the compressor section. Although
the hot gas evaporates water, it is recommended to check and clean it once a month.
PICTURE 12
PICTURE 13
PICTURE 14